Fusion EL Series 6.5" 80W marine speakers gray Sports edition with RGB LED lighting

These Fusion marine loudspeakers have a 6.5-inch diameter and 80 W power output.

These Fusion marine loudspeakers are sold in pairs.

These speakers feature built-in RGB LED lighting, allowing you to customize the lighting ambiance. You can select from several static colors (red, green, blue, yellow, magenta, cyan, white) or use an LED controller for dynamic effects.

Yes, the front face of the speakers is protected against water and dust ingress. However, the rear of the speaker, including all components and connected wires, is not waterproof and must be protected from moisture. Moisture exposure at the rear of the speaker may cause component failure.

When speakers are properly mounted, the front face is protected against dust and water ingress under normal conditions. The document does not provide specific details on cleaning products to use.

This is the Sports edition of marine speakers in gray, with a modern and sleek design.

For installation, you will need the following tools:

An electric drill and a bit (size varies depending on the surface material). A suitable saw or utility knife to cut the surface material. A Phillips screwdriver. Wire strippers. 16 AWG (1.3 to 1.5 mm²) tinned marine-grade speaker wire. 20 AWG (0.5 mm²) tinned marine-grade copper wire for LED connections. 6.3 mm and 4.8 mm female spade connectors (recommended). 4 mm male and female pin connectors for LED wires (recommended for LED models). A crimping tool. Marine-grade sealant (optional).

The diameter of the cutout required for installing these speakers is 130 mm (5 1/8 inches).

If you do not want to install an LED controller, you can set a static color by connecting LED wires to ground.

The black wire of the LED cable must be connected to a positive source (via a fuse). The ground wire must be connected to the LED color wire(s) according to the desired color:
Red: Red wire
Green: Green wire
Blue: Blue wire
Yellow: Red and green wires combined
Magenta: Red and blue wires combined
Cyan: Blue and green wires combined
White: Red, green, and blue wires combined
The LED color wires are terminated with 4 mm male pin connectors, and the black wire with a 4 mm female pin connector.

It is recommended to install an LED lighting controller module with these speakers to turn the LEDs on and off, change colors, and create lighting effects. If you choose not to install one, you can set a static color by connecting the LED wires directly to the power source.

You must install a 500 mA inline fast-blow fuse on the positive wire at the power source end of the LED cable for each speaker. This fuse must be a fast-blow type and installed in a fuse holder rated for marine use.

It is recommended to use 6.3 mm and 4.8 mm female spade connectors to connect speaker wires to the terminals.

Use a marine-grade LED cable of 20 AWG (0.5 to 0.75 mm²) or thicker to connect LEDs to the battery. The marine-grade LED cable 010-13386-00 is specifically recommended.

These speakers can be connected to your stereo or an amplifier. Ensure the audio system is compatible with 80 W speakers and use the correct wiring (16 AWG for speakers, 20 AWG for LEDs).

The warranty may be voided if the rear of the speaker is exposed to moisture or suffers damage. Additionally, failing to protect all terminals and connections from grounding or cross-connections may cause permanent damage to the audio system and void the product warranty.

Yes, it is important not to overtighten the screws when mounting speakers to the mounting surface, especially if the surface is not perfectly flat. Also, do not apply grease or lubricant to the screws, as this could damage the speaker.