Fusion Marine Speakers EL Classic 6.5" White 80 W (pair)

These Fusion marine speakers have a peak power of 80 W and an RMS (Root Mean Square) power of 20 W. RMS power is the continuous power the speaker can handle.

These Fusion EL Classic speakers have a 6.5-inch (approximately 16.5 cm) diameter.

These Fusion marine speakers are sold in pairs.

These marine speakers are white and belong to the Classic edition of the Fusion EL series.

Yes, the front of these speakers is protected against water and dust ingress with an IP65 waterproof rating. However, the rear of the speaker, including all components and connected wires, is not waterproof and must be protected from moisture.

No, this specific model of Fusion EL Classic 6.5" 80 W marine speakers is not equipped with LED lighting.

The required cutout diameter for installing these speakers is 130 mm (5 1/8 inches).

For installation, you will need the following tools:

Electric drillDrill bit (size varies depending on surface material)Appropriate saw or utility knife for cutting surface materialPhillips screwdriverMarine-grade tinned copper speaker wire 16 AWG (1.3 to 1.5 mm²)6.3 mm and 4.8 mm female spade connectors (recommended)Crimping toolMarine sealant (optional)

When selecting a mounting location, consider the following:

Select a location that protects the rear of the speaker from moisture. Ensure sufficient clearance for the speaker’s mounting depth. Choose a flat, vertical mounting surface for better waterproofing. Protect wires from sharp objects and use rubber grommets when routing wires through panels. Mount speakers well above the waterline if installed outdoors.

Yes, it is crucial to protect the rear of speakers from moisture. The rear of the speaker, including all components and connected wires, is not waterproof. Exposure to moisture at the rear of the speaker can cause component failure and void the product warranty.

Use 16 AWG (1.3 to 1.5 mm²) fully tinned marine-grade copper speaker wire to connect speakers to your audio system.

Yes, it is strongly recommended to use the mounting template provided in the product box. If you print a template yourself, you must follow the printing instructions precisely to ensure the correct cutout size.

These speakers have an impedance of 4 ohms.

Yes, you must disconnect the boat's electrical power before starting installation of this device to avoid serious injury or equipment damage.

The warranty may be void if the rear of the speaker is exposed to moisture, as this part is not waterproof. Additionally, damage resulting from an improperly cut mounting surface or failure to follow installation instructions (such as not protecting terminals and connections) may also void the warranty.

Yes, it is strongly recommended to have your audio system installed by a professional installer to ensure optimal performance and avoid personal injury or material damage.

Yes, continuous exposure to sound pressure levels above 100 dBA can cause permanent hearing loss. The volume is typically too high if you cannot hear people speaking around you. It is advisable to limit listening time at high volume. If you experience ringing in the ears or muffled speech, stop listening and have your hearing checked.