Swivel mount bracket for tower speaker, 2.25 in (M-SWMCPv3-2.250)

This is a marine audio mount for enclosed tower speakers, designed to be installed on a swivel bar.

The mounting bracket brand is JL Audio.

This mount is specifically designed for installation on a swivel arm with a diameter of 2.25 inches. The model is M-SWMCPv3-2.250.

Yes, this is a swivel mounting bracket. It allows the speaker to swivel up to 205.5 degrees clockwise and up to 128.5 degrees counterclockwise.

The mount is supplied with the following items:

Silicone adhesive. Butt connectors for speaker cable connections.

This bracket is designed specifically for JL Audio ETXv3 sealed enclosure systems.

No, this model (M-SWMCPv3-2.250) is specifically designed for 2.25-inch diameter bars. It is important to select the mount corresponding to your bar's diameter.

No, swivel mounting brackets must be attached only to horizontal bars.

ETXv3 speakers must be mounted directly above (12 o'clock position) or directly below (6 o'clock position) a horizontal bar. It is important not to mount them in any other position on a horizontal bar.

To adjust the speaker angle, follow these steps:

Remove the mounting screws and washers from the speaker. Rotate the enclosure to the desired angle. Reinstall and tighten the star-head mounting screws.

For Sport grille models only, remove the adhesive mount and install the JL Audio logo badge.

For optimal adhesion, clean the inside of the aluminum cap with acetone (not included) before applying a circular bead of silicone adhesive (included) approximately 1/2 inch (13 mm) from the outer edge.

Silicone adhesive requires at least 24 hours to cure completely. It is recommended to use masking tape (not included) to hold the cap in place during this time.

The speaker cable can be routed through the mounting pipe or, if that is not possible, through one of the openings on the side of the bracket.

You will need to drill a 1/2-inch hole (approximately 12.7 mm) at the marked location for the speaker cable.

To ensure the bracket is level, adjust the mounting angle until it is level, then mark the hole location for the speaker cable before drilling.

Yes, once the speaker is turned to the desired angle, you must install and fully tighten the 5/16 - 18 x 1/2" adjustment screw into the mounting base.

Yes, it is recommended to have someone hold the enclosure during the sliding stage of the mount onto the pipe and while connecting the cables.

JL Audio warrants this product against defects in materials and workmanship for a period of two (2) years from the original purchase date.

No, the warranty is not transferable and applies only to the original buyer from an authorized JL Audio dealer.