Electric windlass VX2 12V-700W - wildcat Ø 8 mm

The Lewmar VX2 windlass operates on a 12V power supply and has a power output of 700W.

This windlass model is equipped with a 8 mm gypsy.

The Lewmar VX2 windlass has an IP67 waterproof rating, meaning it is protected against temporary immersion and dust.

No, Lewmar windlasses are designed and supplied solely for anchor control in marine applications and must not be used for any other purpose.

Lewmar recommends a minimum deck thickness of 40 mm (1 1/2") for installing this windlass. For thicker decks, a longer shaft may be required (non-standard). For thinner decks, a deck spacer (part number 65100038) is available.

For the mechanical installation of the VX2 windlass, you will need the following tools:

A 10 mm (3/8”) drill bit
A 14 mm (9/16”) drill bit
An 18 mm (45⁄64”) drill bit
A 46 mm (1 13⁄16”) hole saw
A 67 mm (2 7⁄16”) hole saw
Crimping pliers and a wire stripper are also required for the electrical installation.

The line coming from the bow roller must be fed horizontally upward to the top of the gypsy and along its central axis, with a tolerance of ±5°.

Yes, there must be sufficient vertical drop of at least 300 mm (12") for the chain or rope during retrieval to prevent any jamming.

Yes, thin decks, or those built with foam or balsa core, will require reinforcement to distribute the loads applied to the deck when the windlass is in use. If in doubt about the deck construction, consult a qualified marine engineer.

After drilling the holes, it is recommended to apply a suitable marine sealant to the freshly cut edges to help prevent water absorption by the deck. Do not use permanent adhesive/sealant such as 5200.

This product requires installation by a suitably qualified marine electrician. It is essential to ensure the boat's battery power is disconnected before starting installation.

The motor/gearbox must not be positioned under the fall zone of the rope or chain. It is important to check the clearance under the deck before cutting and ensure that the mounting surfaces of the motor/gearbox and windlass are parallel.

The 8 mm gypsy of this windlass is compatible with 8 mm ISO 4565 chain, 8 mm DIN766 chain, and 5/16" G40 chain.

For this windlass, nylon windlass-grade ropes with medium lay, 12 to 16 mm (1/2” to 5/8”) diameter for 3-strand and 8-braid ropes, are recommended.

Ropes and chains from other manufacturers may have variations in diameter and elasticity. They may therefore require testing to determine the optimal size and ensure a proper fit with the gypsy. If you encounter difficulties, consult your local agent or Lewmar’s distributor network.

Yes, it is recommended to use only genuine Lewmar parts and accessories to ensure optimal performance and reduce the risk of voiding the warranty.

Yes, the VX range of windlasses' wildcats are ideally suited for handling factory-made Lewmar rope/chain combinations, which consist of rope spliced to a chain tail.

If you are unsure about the compatibility of a sprocket with your chain, consult your local agent or Lewmar’s international dealer network for precise advice.

The built-in circuit breaker in this product is designed to protect the motor and cables from overheating and damage. It is therefore imperative never to disable or bypass it.

The 8 mm (5/16”) hybrid wildcat of your Lewmar VX2 windlass is compatible with the following chain and rope types:

Chain: 8 mm ISO 4565 8 mm DIN766 5/16” G40 Rope: Diameter: 12–16 mm (1/2” – 5/8”) Type: 3-strand and 8-plait