Electric windlass VX2 700W - 10 mm ISO wildcat

The Lewmar VX2 electric windlass has a power output of 700W.

The Lewmar VX2 700W windlass requires a 12VDC power supply.

This Lewmar VX2 windlass model is fitted with a 10 mm gypsy compatible with ISO-type chains.

No, Lewmar windlasses are designed and supplied solely for anchor handling in marine applications and must not be used for any other purpose.

No, a windlass must never be used as a cleat. The anchor rode must always be secured to a cleat, a chain stopper, or a designated anchor point. Using the windlass to secure the rode will damage it.

Ensure there are no swimmers or divers nearby when anchoring.
Keep hands, fingers, clothing, and hair away from the windlass, anchor rode, and anchor during operation.
The circuit breaker must never be disabled or bypassed; it protects the motor and cables from overheating.
Always turn off the windlass at the circuit breaker/isolation switch when not in use.
Do not operate the windlass under the influence of alcohol or drugs.

The Lewmar VX2 windlass is a vertical model.

Lewmar recommends a minimum deck thickness of 40 mm (1 1/2”) for installing the VX2 windlass. For thicker decks, a longer shaft may be required, and for thinner decks, a deck spacer is available.

For installing the VX2 windlass, you will need:

10 mm (3/8”) and 14 mm (9/16”) and 18 mm (45/64”) drill bits.Large hole saws of 46 mm (1 13/16”) and 67 mm (2 1/4”).A crimping tool / wire stripper.Appropriate electrical cables and crimp terminals.Suitable marine sealant.

The installation location must be flat and carefully selected, taking into account the position of the bow roller, the chain locker below, and the rotation of the manual control handle. It is critical to ensure sufficient clearance for the engine/reduction gear under the deck.

Yes, there must be a sufficient vertical drop of at least 300 mm (12 in) for the chain or rope during retrieval. Failure to meet this requirement may cause jams.

After drilling the required holes and applying marine sealant to the cut edges to prevent water absorption:

Assemble and tighten the studs into the base until they bottom out. Place the base mat on the deck. Apply appropriate sealant to the windlass base or around the studs (allow the sealant to cure before the final tightening of the mounting nuts if using a silicone-type sealant). Lightly coat the shaft with grease and ensure the drive key is in place before assembly to the motor/reduction gear.

The mounting studs of the VX2 windlass must be tightened to a torque of 21 Nm. It is recommended to use Loctite® thread locker to secure the M8 nuts.

Yes, thin decks, or those constructed from foam or balsa sandwich, will require reinforcement to distribute the loads applied to the deck when the windlass is in use. Consult a qualified marine engineer if in doubt.

For the 10 mm ISO gypsy, use windlass-grade nylon ropes with medium lay, 12 to 16 mm (1/2" to 5/8") diameter, 3-strand and 8-plait construction.

Yes, but windlasses are ideally suited to combined rope/chain mooring lines factory-made by Lewmar. Ropes from other manufacturers may vary in elasticity and diameter, sometimes requiring tests to determine the optimal size.

No, the 6 mm hybrid sprocket used on the VX2 models is not compatible with the 6 mm ISO chain. A specific sprocket kit is available for the 6 mm ISO chain, using a modified sprocket from the CPX2/3 models.

Use only genuine Lewmar parts and accessories to ensure optimal performance and avoid voiding your warranty.

To obtain the CE approval certificates for the Lewmar VX2 windlass, you must contact Lewmar directly.