VeX PS-SWMCP-B Mounting Hardware for 2.25" Bar

This mount is a swiveling mounting bracket designed specifically for JL Audio VeX™ marine sealed speaker systems. It allows these speakers to be attached to 2.25-inch round bars, providing flexible orientation.

This mounting bracket is designed to be installed on round bars with a diameter of 2.25 inches (approximately 5.7 cm).

The mounting bracket is supplied with the following hardware:

4 x Axia Alloys hose clamps
6 x M6 x 16 mm socket head screws
2 x M4 x 4 mm set screws (pre-installed)
4 x M6 nylon-insert locknuts
2 x hose clamp receivers
1 x Loctite® red thread locking compound
4 x M6 flat washers
4 x M6 x 45 mm socket head screws
1 x Plastic strip

No, this mount is specifically designed for JL Audio VeX™ marine closed speaker systems, such as the PS650-VeX™ closed speaker systems.

Yes, the mounting bracket is manufactured in the United States by Axia Alloys and is protected by U.S. patents.

JL Audio warrants this product against defects in materials and workmanship for a period of two (2) years from the original date of purchase.

Yes, the Loctite® red thread-locking compound is included and must be applied to certain M6 x 16 mm screws during installation to ensure secure fastening.

Yes, this is a swivel mount that allows you to rotate the speaker to the desired angle after installation on the rail.

Yes, a plastic strip is provided and must be placed around the shaft before installing the clamps to prevent scratching the shaft surface.

The warranty covers defects in materials and workmanship. If warranty service is required, JL Audio will repair or replace the defective product at its discretion, free of charge.

The warranty does not cover damage caused by:

Accident, misuse, abuse, modification, or negligence of the product.
Failure to follow installation instructions.
Unauthorized repair attempts.
False statements by the seller.
Incidental or consequential damage.
Aesthetic damage due to an accident or normal wear.

Yes, this mount is specifically designed as a swivel fitting for round pipes, as stated in the technical documentation.

Silicone adhesive is required to attach the aluminum logo cap to the back of the enclosure. However, silicone adhesive is typically included with VeX™ speaker systems themselves, not with this mounting bracket.

Before securing the cap, clean the inside of the cap with acetone (not included). Then apply a circular bead of silicone adhesive inside the cap, 1/2 inch (13 mm) from the outer edge, and press it onto the back of the housing. Use masking tape (not included) to hold the cap in place for at least 24 hours to allow the silicone to cure.

No, the warranty is not transferable and applies only to the original buyer from an authorized JL Audio dealer.

Yes, if you want to rotate the badge/logo on the speaker grille to align it, you must remove the six mounting screws from the speaker and the #8 flat washers, then rotate the speaker to the desired angle before reinstalling it and tightening the screws in a cross pattern.

This mounting bracket is protected by US patents no. 8,136,771 and no. 8,398,035.

Two M4 x 4 mm set screws are preinstalled in the collar receiver of the mount.

The installation documentation states to fully tighten the screws after applying Loctite® thread locking compound, but does not specify precise torque values in foot-pounds or Newton-meters.

This bracket is specifically designed and sized for JL Audio VeX™ sealed enclosure systems. There is no indication of compatibility with speakers from other brands.