VeX 0.875" bar mount for PS-SWMCP-B

This bracket is designed for mounting JL Audio VeX™ enclosed speaker systems on round bars aboard your boat. It allows secure and adjustable installation of your marine speakers.

This mount is specifically designed to be installed on bars with a diameter of 0.875 inches (approximately 2.22 cm).

The kit includes the following items:

4 x Axia Alloys hose clamps
6 x M6 x 16 mm cheesehead screws
2 x M4 x 4 mm set screws (pre-installed)
4 x M6 nylon-insert locknuts
2 x clamp receivers
1 x Loctite® red threadlocker
4 x M6 flat washers
4 x M6 x 45 mm cheesehead screws
1 x protective plastic strip

Yes, this mounting bracket is manufactured in the United States by Axia Alloys.

Yes, this mount is protected by US patents #8,136,771 and #8,398,035.

No, some parts such as the mounting base, silicone adhesive, #8 flat washers and #8 x 1-1/4" pan head screws are typically included with the VeX™ sealed enclosure systems themselves, not with this PS-SWMCP mounting kit. This kit provides the components to secure the bracket to the tiller and connect it to the enclosure base.

This mount is specifically designed for use with JL Audio VeX™ closed-box speaker systems (e.g., PS650-VeX models).

No, this mount is specifically designed as a "swivel mount for round pipes" and is not suitable for square or oval shaped bars.

This bracket is optimized and designed for JL Audio VeX™ sealed enclosure systems. While it may technically fit other speakers with a compatible mounting base, compatibility and optimal performance are guaranteed only with JL Audio VeX™ products.

Yes, the kit includes Loctite® red thread-locking compound. It is recommended to apply it on certain M6 x 16 mm screws and on the central M6 x 16 mm screw of the clamp receiver to ensure secure fastening.

A plastic strip is provided in the kit. It is recommended to place it around the tiller before pushing the hose clamps to prevent scratches.

Yes, you can adjust the speaker’s angle. To do so, remove the six mounting screws and #8 washers from the speaker, rotate the speaker to the desired angle, then reinstall the screws and washers, tightening them in a cross pattern by hand.

For Premium models, clean the inside of the aluminum cap with acetone. Apply a circular bead of silicone adhesive inside the cap, about 13 mm from the outer edge. Align the cap to the desired angle and press it onto the back of the enclosure. Use masking tape to hold it in place until the silicone cures (at least 24 hours).

Yes, the installation steps for the mounting bracket are identical for all PS650-VeX sealed speaker systems and all PS-SWMCP swivel mounts for round pipes.

Yes, the steps for aligning and securing the aluminum logo cap (steps 13–14 of the installation manual) apply specifically to the "Premium" speaker models and do not apply to the "Standard" models.

After pushing the clamps onto the tiller, you must align them with the clamp receiver located on the housing to ensure correct and secure installation.

This product is covered by a limited warranty of two (2) years from the original purchase date.

The warranty covers material and manufacturing defects. In the event of a manufacturing defect or malfunction, JL Audio will repair or replace the defective product at its discretion.

The warranty does not cover damage caused by an accident, misuse, abuse, unauthorized modification, or neglect of the product, failure to follow installation instructions, unauthorized repair attempts, or false statements by the seller. It also does not cover cosmetic damage resulting from an accident or normal wear and tear.