VeX™ mounting bracket for enclosed speaker system, 1.875" bar (PS-SWMCP-B-1.875)

The JL Audio PS-SWMCP-B-1.875 marine audio mount is a swivel mounting bracket designed specifically for JL Audio VeX™ enclosed marine speaker systems. It allows mounting these speakers on round bars with a diameter of 1.875 inches (approximately 4.76 cm).

The SKU (Stock Keeping Unit) for this mounting bracket is 010-13690-00.

This product is from the JL Audio brand. Although the mounting hardware is manufactured in the United States by Axia Alloys, it is marketed under the JL Audio brand as an accessory for their marine audio systems.

Yes, this mount is a swivel fixture that allows you to rotate the enclosure to the desired angle after installation.

This mounting bracket is specifically designed to be installed on round bars with a diameter of 1.875 inches (approximately 4.76 cm).

Yes, this mount is specifically designed for JL Audio PS650-VeX™ marine sealed enclosure systems.

No, this mount is a swivel bracket designed exclusively for round bars. It is not compatible with square or oval bars.

No, this mount is specifically designed to fit JL Audio VeX™ enclosed speaker systems and is not guaranteed to be compatible with speakers from other brands.

The mounting bracket is supplied with the following items:

Axia Alloys hose clampsM6 x 16 mm and M6 x 45 mm cheese-head screwsM4 x 4 mm set screwsNylon insert nutsHose clamp receiversThread-locking compound (Loctite® Red)M6 flat washersPlastic stripPlease note that the mounting base, silicone adhesive, #8 flat washers, and #8 x 1-1/4" cheese-head screws are included with VeX™ speakers, not with this mounting bracket alone.

Yes, a tube of Loctite® Red thread-locking compound is included with the mounting bracket to secure the M6 screws.

No, the silicone adhesive is not included with this mounting bracket. It is supplied with the VeX™ speakers themselves.

To secure the enclosure to the mount, apply Loctite® Red Threadlocker to two M6 x 16 mm screws, insert them through the slots of the clamp receiver and into the appropriate holes in the mounting base, then tighten them fully.

To adjust the angle, you can rotate the speaker to the desired position. Then reinstall the speaker mounting screws and washers, tightening them by hand in a cross pattern.

Yes, it is recommended to use the supplied plastic strip by placing it around the shaft before pushing the clamps. This helps prevent scratches on the shaft surface.

The mount is supplied with the necessary hardware for its own attachment to the tiller and to the VeX™ speakers. However, certain mounting-specific components (such as the mounting base, silicone adhesive, #8 washers, and #8 x 1-1/4" screws) are included with the VeX™ speaker systems themselves, not with this mount alone.

JL Audio warrants this product against defects in materials and workmanship for a period of two (2) years from the original date of purchase.

The warranty does not cover damage caused by:

AccidentsIncorrect use or abuseModification or neglect of the productFailure to follow installation instructionsUnauthorized repair attemptsFalse statements by the sellerIt also does not cover cosmetic damage resulting from an accident or normal wear.

No, the warranty is not transferable and applies only to the original buyer from an authorized JL Audio dealer.