Mounting bracket for tower speaker, 1.315" bar (M-MCPv3-1.315)

This swivel mount bracket is designed to be attached exclusively to horizontal rails.

This specific mounting bracket is designed to be compatible with bars having a diameter of 1.315 inches.

No, the ETXv3 speakers must be mounted only directly above (12 o'clock position) or directly below (6 o'clock position) a horizontal bar.

The mount allows a maximum rotation of 205.5 degrees clockwise and 128.5 degrees counterclockwise.

The speaker cables can be routed in two ways:

Through the mounting bar itself. Via one of the openings on the side of the bracket.

Yes, if you choose to route the cable through the tiller, you must drill a 1/2" hole (approximately 13 mm) at the marked location.

To adjust the speaker angle:

Remove the mounting screws and washers from the speaker. Rotate the enclosure to the desired angle. Reinstall the speaker mounting screws and washers, hand-tighten in a cross pattern.

Yes, a circular bead of silicone adhesive is included with the product and must be applied inside the aluminum logo cap, approximately 13 mm from the outer edge. For better adhesion, it is recommended to clean the inside of the cap with acetone (not included) before application.

For installing the logo cap, in addition to the supplied silicone adhesive, it is recommended to use:

Acetone (not included) to clean the inside of the aluminum cap.Masking tape (not included) to hold the cap in place until the silicone cures (at least 24 hours).

Once you have rotated the enclosure to the desired angle, you must install the 5/16 - 18 x 1/2 inch adjustment screw in the base of the bracket and tighten it fully.

This swivel mount is specifically designed for use with JL Audio ETXv3 sealed enclosure systems.

The warranty for this JL Audio product is two (2) years from the original purchase date.

No, the warranty is not transferable and applies only to the original buyer who purchased the product from an authorized JL AUDIO dealer.

The warranty covers defects in materials and workmanship. In the event of a manufacturing defect or malfunction, JL AUDIO will repair or replace the defective product, at its discretion, with a new or refurbished product free of charge.

The warranty does not cover damage caused by:

An accident, misuse, abuse, modification, or neglect of the product.
Failure to follow installation instructions.
Unauthorized repair attempts or false statements by the seller.
Incidental or consequential damage.
Aesthetic damage due to an accident or normal wear.

No, the warranty does not cover removal or reinstallation costs of the unit(s).

No, JL Audio products purchased outside the United States are covered only by the warranty of the distributor in the relevant country and not by JL Audio, Inc. (USA).

The logo cap is made of aluminum.

Yes, the mount is supplied with an aluminum logo cap. This cap can be aligned to the desired rotation angle and pressed onto the back of the enclosure. A self-adhesive logo badge is also mentioned for Sport grille models only.