Navico Naviop LOOP S Digital Switching System kit

The Naviop LOOP S Digital Switching System kit is a compact and easy-to-install digital switching solution designed primarily for small boats. It enables centralized control and monitoring of onboard systems via an integrated sidebar on a compatible multifunction display. It can also serve as a backup solution for larger vessels.

The system is powered by a 9 to 32 V DC source for the OP-Box. The Egon+ board, the central component of the LOOP S, operates on 8 to 16 V DC (nominal 12 V DC).

The Naviop LOOP S system, via its Egon+ distribution card, provides 8 fused relay channels and 8 fused channels without relay control, for a total of 16 output channels.

At 12 V DC, the fuse channels support up to 30 A. Combined relay and fuse channels support 20 A for resistive loads and 16 A for inductive loads (motors, pumps).

The total current limit for the entire system is 200 A. The system has two M8 input terminals, each supporting up to 100 A.

Temperatures vary depending on the components:

The OP-Box operates between -15°C and +55°C and is stored between -20°C and +70°C. The Egon+ card operates between -40°C and +85°C and is stored between -40°C and +125°C.

The OP-Box has an IPx7 protection rating, meaning it is protected against temporary immersion. The Egon+ card has an IP66 protection rating, indicating protection against dust and powerful water jets.

Yes, the system has electronic input protection. It includes reverse polarity protection (up to -24 V DC for 5 minutes) and short-circuit protection (short to ground and short at 16 V DC for 5 minutes).

Yes, the system is protected against ignition ONLY when equipped with ignition-protected fuses and its cover is closed.

The OP-Box consumes a maximum of 0.15 A at 24 V DC. The Egon+ board has a standby current consumption of 1.5 mA.

The Naviop LOOP S system is compatible with multifunction displays from brands such as Lowrance, Simrad, and B&G, allowing control via an integrated side panel.

The system has multiple communication interfaces:

Two Ethernet ports (10/100) One USB port (Host v. 2.0, max. 100 mA) Two serial ports (RS-232, RS-485, RS-422, software-configurable, optical isolation) Two CAN bus ports (optical isolation - 1kV)

The Naviop LOOP S is primarily designed for small boats. It can also serve as a backup solution for larger vessels.

Yes, this product is compliant with the EU EMC Directive 2014/30/EU.

The system uses two M8 input terminals for the main power supply, each designed to handle a maximum of 100 A.

Recommended wire size for outputs is 1.31 mm² to 5.26 mm² (equivalent to #10-16 AWG).

Yes, the Naviop LOOP S Digital Switching System kit is described as a compact and easy-to-install solution.

The Egon+ chartplotter is designed to withstand harsh environmental conditions, including mechanical shock (per SAE J2030), sandblasting tests (24 hours of dust, sand, and gravel), salt spray (96 hours per ASTM B117-94), and vibrations (per SAE J1455). It also offers chemical resistance to common fluids such as brake fluid, automatic transmission fluid, antifreeze, windshield washer fluid, power steering fluid, and oil.

The Naviop LOOP S kit includes an Egon+ card, which is the central component of the digital switching system.

The power wire gauge must be calculated based on the board's total power consumption. The total current limit is 200 A, with a maximum of 100 A per M8 input connector.