XSONIC Airmar B60 (20°)

The XSONIC Airmar B60 (20°) transducer is a 600 W through-hull transducer that provides depth and water temperature sensing. It features Airmar’s Tilted Element™ technology and operates on two frequencies, 50 kHz and 200 kHz. The housing is bronze and the element is tilted at 20°.

The XSONIC Airmar B60 (20°) transducer has a power output of 600 W.

The B60 transducer operates on two distinct frequencies:

At 50 kHz, it provides a wide 45° beam. At 200 kHz, it provides a 12° beam.

The B60 transducer reaches a maximum depth of 366 meters (1200 feet) at 50 kHz. At 200 kHz, it provides precise target details down to 213 meters (700 feet).

Yes, the XSONIC Airmar B60 (20°) transducer has an integrated sensor for water temperature detection.

Airmar’s Tilted Element™ technology integrates a tilted ceramic element inside the transducer. For the B60 (20°), this element is tilted at 20° to compensate for hull angles ranging from 16° to 24°. This ensures the sonar beam is directed vertically toward the seabed, optimizing accuracy and performance.

The housing of the XSONIC Airmar B60 (20°) depth sounder is made of bronze.

The B60 transducer is fitted with a 9-pin black connector and comes with a 10-metre (33-foot) cable.

The Airmar B60 transducer with bronze housing is recommended for fiberglass or wood hulls.

No, it is imperative never to install a transducer with a bronze housing, such as the B60, on a metal hull. This would cause electrolytic corrosion.

The B60 (20°) transducer is designed for hulls with a deadrise angle between 16° and 24° at the mounting point. Its 20° angled element compensates for this angle to provide a vertical beam.

Yes, the XSONIC Airmar B60 (20°) transducer is a hardware accessory compatible with Lowrance equipment, including sonars, sensors, transducers, scanners, and Airmar Tilted Element antennas.

For optimal performance, the B60 transducer must be positioned in an area with smooth water flow, minimal bubbles and turbulence, and where the transducer will remain continuously submerged. The beam must not be obstructed by the keel or propeller shafts. It is also recommended to keep it away from sources of electrical or mechanical interference. The exact location depends on the type of boat (displacement hull, planing hull, sailboat, etc.).

Yes, it is crucial that the arrow on top of the transducer points toward the keel or the centerline of the boat. This ensures the internal element angle of the depth sounder is correctly aligned with the hull’s deadrise angle, guaranteeing optimal sonar beam performance.

Yes, using a suitable marine sealant for an application below the waterline is mandatory to ensure the watertight integrity of the B60 transducer installation.

It is critical to immediately check for leaks when the boat is launched after installing the transducer. Do not leave the boat unattended for more than three hours, as even a small leak can lead to significant water accumulation.

Yes, applying a water-based antifouling paint is mandatory in saltwater to protect the B60 transducer from marine growth.

The Foulfree coating is Airmar-certified as having no negative impact on transducer performance. It is a non-toxic, eco-friendly solution that creates an ultra-smooth surface preventing marine growth from adhering to the transducer. A 15 ml tube covers approximately 0.09 m² and provides protection lasting up to two years.