POD for TZT9F - uncut front (Max usable surface: 349x229mm)

The Scanstrut POD SW-SP3P is a deck-mount solution designed for the integration and protection of marine electronic displays, including the Furuno TZT9F. It comes with an uncut front panel, allowing precise adaptation to your equipment.

The Scanstrut POD SW-SP3P is made of ABS plastic capped with acrylic. This composition ensures robustness, corrosion resistance, and excellent UV stability. The pod’s seal is made of high-tear-resistance silicone.

Yes, its ABS plastic construction capped with acrylic gives it robustness and resistance to corrosion and UV, essential in a marine environment. The silicone gasket also provides protection against heat and UV rays, ensuring effective protection for the electronics.

The maximum usable surface on the undrilled front of the Scanstrut POD SW-SP3P is 349x229mm. This allows precise cutting to match your equipment's dimensions.

The POD is designed with watertight cable routing. This feature ensures that your devices' connections remain protected from water and moisture in the marine environment.

An internal reinforcement plate is integrated into the POD to increase its rigidity. This feature helps minimize potential damage from impacts and vibrations, providing better protection for your electronic equipment.

No, the Scanstrut POD SW-SP3P comes with an uncut front panel. This design gives you the flexibility to make a custom cut to perfectly fit the dimensions of your display or other equipment.

Yes, the pod’s seal is made from high-tear-resistance silicone. This material is selected for its ability to provide effective protection against heat and UV rays, thereby contributing to the durability and watertight integrity of the assembly.

Yes, the Scanstrut POD SW-SP3P is designed for integrating the Furuno TZT9F display. However, thanks to its uncut front panel, it offers flexibility for other equipment.

Yes, thanks to its uncut front panel and a maximum usable surface area of 349x229mm, this POD can accommodate other brands and models of displays, including 9-inch screens, provided their dimensions fit within this surface area.

The POD is suitable for 9-inch displays, but the main constraint is the maximum usable surface area of 349x229mm. It is essential to verify that your display's dimensions (height and width) do not exceed these measurements.

To check compatibility, you must measure the external dimensions (height and width) of the device you wish to install. These dimensions must be less than or equal to the maximum usable surface of the POD, i.e. 349x229mm.

The Scanstrut POD is a protective enclosure and does not interfere with the touchscreen functionality. Touchscreen compatibility depends on the screen itself and its ability to operate in a mounted environment.

Although it is optimized for screens, its uncut front panel allows integration of other marine electronic instruments. The only requirement is that their dimensions respect the maximum usable area of 349x229mm.

The POD comes with the necessary fasteners for installation on the deck. However, the specific screws to mount your display inside the POD typically depend on the display model and are not included with the POD.

The Scanstrut POD SW-SP3P is installed from rear to front. The fasteners cut threads into ABS injection-molded inserts, ensuring a quick and secure installation on your boat’s deck.

Yes, the POD is equipped with a quick-release swivel and tilt base. Additionally, a ball joint allows for 360-degree adjustment, giving you the flexibility to set the screen to the optimal viewing angle.

Cutting the display housing requires precision and the right tools (e.g., a jigsaw with a fine-tooth blade for plastic, or a router). It is recommended to carefully follow the manufacturer's instructions for the cutting template to achieve a clean and accurate result.

Yes, installing from the rear forward, combined with the quick-release mounting system, makes maintenance easier. This provides simplified access to the electronic equipment if checks or repairs are required.

Installing from stern to bow offers several advantages:

It allows quick and secure mounting of the POD on the deck. It simplifies future maintenance operations, as access to the fastenings is easier. This method contributes to the overall robustness of the installation.