Gulley IC 12 V Shower Drain System

The Gulley IC SG8284 system is designed to be compatible and function with the Whale Gulper® IC range of sewage pumps. It integrates as a grey water management accessory for these pumps.

No, the Gulley IC Whale SG8284 system is specifically designed for a single shower, as indicated by its description "Grey Waste Kit with Single Shower Gulley".

The Gulley IC SG8284 system is typically installed as an accessory for a Whale Gulper® IC grey water pump. It connects to this pump, which functions as a high-capacity grey water drainage pump with integrated smart control, to direct water to the outboard or a grey water holding tank.

The Gulley IC Whale SG8284 shower drain system operates on 12 V DC (direct current).

The Gulley IC Whale SG8284 grey water drainage system is designed for managing grey water aboard pleasure craft. It allows the drainage of water from a single shower.

The Whale Gulley IC SG8284 system operates on a 12 V direct current (d.c.) power supply. Its operating voltage range is from 10 V d.c. to 13.6 V d.c.

The Gulley IC system is fitted with grooved fittings designed to connect to 19 mm (¾") or 25 mm (1") diameter hoses.

A 10 ampere automotive fuse is recommended to protect the Gulley IC 12 V system. It is essential that the wiring complies with applicable electrical standards and includes a fuse or appropriately sized circuit breaker.

The minimum recommended wire size for installing the Gulley IC system is 1.5 mm² (16 AWG).

The Gulley IC system offers the following maximum capabilities:

Maximum vertical suction lift: 3 metres (10 feet).Maximum vertical discharge height: 3 metres (10 feet).Maximum combined vertical suction lift and discharge height: 4 metres (13.5 feet).

The flow performance of the Gulley IC system depends on installation conditions, particularly pipe size, suction height, and discharge height. For example, with a 19 mm (¾") pipe, 0 m suction height, and 1 m discharge height, the flow rate is approximately 19 litres per minute (1140 litres per hour). With a 25 mm (1") pipe under the same conditions, the flow rate is approximately 17.5 litres per minute (1050 litres per hour).

Yes, the Gulper® IC system can be installed as a grey water pump in conjunction with non-Whale® IC accessories. This allows the installer to use low-current controlled switching, which helps prevent overheating caused by high currents.

The Gulper® IC pump must be mounted on a bulkhead or an additional board. It is important not to screw it directly onto the hull. The mounting surface must have a minimum thickness of 19 mm (¾") for secure fastening with the supplied screws.

Yes, the Gulper® IC pump is a fully automatic and self-priming pump. It is designed to pump wastewater from a shower tray or a kitchen sink.

The Gulley IC system is designed exclusively for installation in recreational vessels and operates on 12 V or 24 V DC power. It is not recommended for household applications or for pumping flammable liquids, diesel, or chemicals.

No, it is imperative not to unscrew the rear section of the pump. Any intervention on the internal electronics would render the pump unusable and void the warranty. The rear section is a non-repairable part of the pump.

At the core of every Whale® IC product is an integrated innovative electronic control circuit. This technology enables IC sensor accessories to communicate directly with IC pumps to control their performance. The accessories send signals to an integrated smart software that then commands the pumps to react as needed, ensuring automatic operation when greywater must be pumped.

If the bilge system is connected to a fitting or outlet located below the waterline, the system must be equipped with a vented loop to prevent siphoning.