Whale Gusher Titan BP4410 manual bilge pump - deck-mounted

Yes, for models designed for through-deck or bulkhead mounting, such as the BP4410, the entry and exit directions can be reversed by following the specific instructions and repositioning the handle.

The Whale Gusher Titan BP4410 model is designed for under-deck mounting or through a bulkhead or deck. It is not a deck-mounted unit.

For installation of model BP4410, deck thickness must be a minimum of 13 mm (1/2 inch) and a maximum of 25 mm (1 inch).

For optimal installation and efficient operation, it is recommended to:

Choose a position free of any obstructions. Ensure the pump can be operated easily and comfortably. Avoid installations requiring opening a cockpit locker to access the pump. Position the pump midway between the bilge strainer (strumbox) and the hull outlet to minimize pumping effort.

After installing the Whale Gusher Titan BP4410 pump, it is essential to perform the following checks:

Check for air leaks in the system. Ensure the pump primes correctly. Confirm proper operation of the discharge. If using a through-hull discharge, ensure the discharge point is located well above the waterline.

The Whale Gusher Titan BP4410 manual bilge pump is specifically designed for manual pumping and efficient draining of your boat's bilge.

The Whale Gusher Titan BP4410 manual bilge pump is designed for draining stagnant water, primarily for drying out boat bilges. It provides efficient manual pumping.

For through-deck or bulkhead-mounted models such as the BP4410, the deck thickness must be a minimum of 13 mm (1/2”) and a maximum of 25 mm (1”).

Yes, for through-hull or bulkhead models (BP4410), a plastic deck plate (part number DP8904) is supplied with the pump.

The inlet and outlet directions can be reversed. Loosen the screws on both sides of the clamp ring, remove the diaphragm, then rotate the pump body to the new position relative to the fork and diaphragm. Finally, reinstall the diaphragm and clamp ring, ensuring the screws are tightened evenly on both sides.

Use a reinforced hose with smooth bore of 1 1/2” (38 mm) and secure it with stainless steel worm-drive hose clamps. Tighten clamps properly to prevent air leaks.

The pumping capacity of the Gusher Titan BP4410 depends on the pumping rate and installation conditions. At 1 meter suction lift and 0.5 meter discharge head, it can reach approximately 90 litres/minute at 60 strokes/minute and 105.6 litres/minute at 70 strokes/minute.

Yes, the pump can be used for other liquids, provided the pump materials are fully compatible with the liquid in question. It is the user's responsibility to ensure this compatibility.

Whale pumps are warranted for 5 years from the date of purchase against material and manufacturing defects. Rubber components are covered by a 1-year warranty.

If the pump fails to prime or clogs, first check that the inlet hose connection is airtight, free of obstructions, and does not collapse during the suction stroke. Inspect the diaphragms and replace them if damaged. Remove any solid objects from the pump body and check the inlet and outlet valves for blockages, then clean them.

Regular inspection of the pump is recommended. Rubber components should be replaced if worn or every three years, regardless of condition.

Two service kits are available: the AK4400 kit for neoprene spare parts (for clean bilge water) and the AK4419 kit for nitrile spare parts (for oily bilge water). It is recommended to keep a service kit on board.

Yes, it is crucial to ensure the pump is installed in a way that allows easy access for maintenance and servicing. This will facilitate regular inspections and part replacements if needed.

The Whale Gusher Titan BP4410 manual bilge pump is manufactured in the United Kingdom.