JL Audio M200 10" subwoofer enclosure, white with LED
Import duties and taxes are payable by you on delivery.
Prices shown excluding VAT for United Arab Emirates. If your delivery address is in the European Union, the VAT of the destination country will be added at checkout.
Awaiting restock
Technical specifications
Technical specifications
| Source type | Subwoofer |
| Speaker Diameter In | 10 |
| Audio Output Power Rms | 250 |
| IP rating | IPX6 |
| Color | White |
| Body diameter | 222 |
| Enclosure Type | Infinite baffle |
| Impedance | 4 |
| Led Fuse Rating Ma | 500 |
| Installation cutout diameter | 222.5 |
| Mounting Depth | 131 |
| Mounting Screw Hole Diameter Mm | 2.78 |
| Mounting type | Flush-mounted |
| Overall diameter mm | 275.4 |
| Rgb Light Wire Colors | Red, Green, Blue |
Detailed description
Detailed description
Marine M200 subwoofer with infinite baffle
The reference 010-04759-00 includes a JL Audio M200 subwoofer with a nominal 10" size, white Sport grille, and RGB LED lighting. This is a flush-mount speaker, not a pre-assembled sealed enclosure.
Audio and rear volume
The speaker accepts 250 W RMS at 4 ohms, with a sensitivity of 86 dB at 1 W/1 m. The recommended amplifier power is 250 W. The cone is made of injection-molded polypropylene.
The infinite baffle design uses a large air volume behind the speaker: the datasheet specifies 56.6 liters and recommends keeping this space empty. A dedicated sealed enclosure is possible according to the recommended dimensions, with 56.66 liters of net internal volume; the volume displaced by the speaker and reinforcements must be added to calculate the gross internal volume. Use of a ported enclosure is not recommended.
Marine flush-mount
Allow for a cutout of 222.5 mm and a mounting depth of 131 mm. The outer diameter is 275.4 mm; the rear body measures 222 mm in diameter, and the front face extends 47.1 mm beyond the mounting surface. Maintain a 295 cm compass distance.
The IPX6 rating applies to front-face protection when the speaker is properly installed. The rear, wires, and connections are not waterproof: protect them from moisture. In areas exposed to water or weather, mount on a vertical surface. Outside the boat, install well above the waterline.
LED lighting
The RGB LEDs operate on 10 to 14.4 V DC, with a maximum current of 220 mA at 14.4 V DC. Garmin recommends a Spectra controller, sold separately. A static color can also be achieved by a protected connection to a 12 V DC source.
Always install a 500 mA fast-blow fuse on the LED positive wire at the power source end, in a marine fuse holder. This remains mandatory even with a controller. For direct wiring, also use an isolation switch or circuit breaker. Use the provided harness and disconnect the audio power before making connections.
Box contents
- One subwoofer and one white Sport grille.
- One 6.3 mm and one 4.7 mm female spade connector.
- One waterproof 4-pin connector.
- Mounting screws and documentation.
Expert opinion
Expert opinion
« Skysat advice: reserve the rear volume and protect the LEDs »
Your payment information and data are processed securely.
