Fusion Signature 3i 8.8" Classic white speakers (pair)

The advertised frequency response is 50 Hz to 20 kHz.

The built-in tweeter uses a silk dome.

IP65 protection applies to the front face when the enclosure is correctly installed. The rear, wires, and connected components are not waterproof and must be protected from moisture.

This Classic white reference does not have LED lighting. The LED sections in the common datasheet apply to other variants.

This reference is sold by pair.

The nominal impedance is 4 ohms per speaker.

True-Marine refers to Fusion’s marine environmental design and testing. It is not an independent certification nor a guarantee of rear watertightness.

Clean salt with a damp cloth and fresh water; use a mild detergent if needed. Avoid solvents and high-pressure jets.

Prepare a drill, a bit suitable for the mounting surface, a saw for cutting, a Phillips screwdriver, and wire strippers. Use tinned marine-grade copper cable of 16 AWG or thicker; connections must be watertight.

The manual prescribes fully tinned marine-grade copper cable of 16 AWG (1.3 to 1.5 mm²) or thicker, with watertight splices. The cable running to the source or amplifier is not supplied.

Protect the rear from moisture. In areas exposed to water or bad weather, use a vertical surface and a location above the waterline. Also respect the 412 cm compass distance.

Display the Fusion grid at the bottom (six o’clock position), then lock it to the edge of the enclosure.

True-Marine refers to Fusion’s marine environmental design and testing. It is not an independent certification nor a guarantee of rear waterproofing.