Cívka série L - 150 A 12/24 V

This solenoid is designed for remote switching of medium-current DC loads in marine and 12V/24V on-board systems. It allows controlling circuits without direct manual intervention on the device.

The L-Series 150A solenoid is designed to operate with 12V or 24V DC nominal voltage systems.

It handles a continuous nominal current of 150 amperes (A) when used with a 2 AWG cable at an ambient temperature of 50°C.

This solenoid is of the SPST (single-pole single-throw) type and is normally open (Normally Open). This means the main circuit is open (disconnected) when the coil is not powered.

The continuous current consumption of the control circuit is 0.13A at 12V and 0.07A at 24V. This low consumption minimizes heat generation and coil power consumption.

Yes, the L-Series 150A solenoid is equipped with hermetically sealed contacts and has IP67 protection. This ensures its waterproofing against immersion up to 1 meter for 30 minutes, making it suitable for harsh marine environments.

The solenoid is designed to operate within a temperature range of –40°C to +85°C.

A solenoid like the L-Series 150A is an electronic switch without direct manual control, used for circuits where a manual battery disconnection is already provided elsewhere. A remote battery switch, on the other hand, is a solenoid or relay with a manual control switch, allowing switching even if the control circuit is compromised, and offering a lock function for maintenance.

The L-Series 150A solenoid is CE certified, attesting to its compliance with European safety, health, and environmental protection standards.

The weight of the L-Series 150A solenoid is 0.43 kg (0.95 lb).

The solenoid is remotely activated via a low-ampere ON-OFF switch, which is sold separately. It has no direct manual control over the device itself.

Main connections are made via M8 studs, which accept 5/16 inch terminals.

The maximum recommended torque for terminal studs is 10 Nm (90 in-lb).

The solenoid can be mounted using #10 or M5 screws.

Recommended tightening torque for mounting screws is 1.7 to 3.4 Nm (15 to 30 in-lb).

For connecting the coil circuit, it is recommended to use a tinned wire of 22 AWG gauge.

Main solenoid dimensions are:

Maximum width: 58.2 mm (2.29 in)Maximum height (excluding terminals): 68.3 mm (2.69 in)Maximum depth: 80.8 mm (3.18 in)Distance between mounting hole centers: 73.7 mm (2.90 in)

This solenoid is suitable for applications requiring switching of loads under 150A. This includes DC subpanels, bow thrusters, windlasses, or moderate power inverters.

The solenoid has an intermittent current capacity of 225A (for 5 minutes) and a starting current capacity of 600A (for 30 seconds).

The control circuit for the solenoid coil accepts an input voltage range of 9V to 36V DC.