LUX SNL180, Neon Flex Superbright strip, 2200 mm

The Garmin LUX SNL180 light strip measures 2200mm in length. It is important to note that it is supplied in pre-cut, factory-sealed lengths and must not be cut under any circumstances.

This LED strip provides a full CRGBW spectrum, including cool white, red, green, blue, and warm white. Additionally, the white color temperature is fully adjustable, ranging from 2700K to 6500K.

Yes, the LED strip is designed with an IP67 protection rating, making it perfectly suitable for indoor and outdoor installations on a boat, specifically above the waterline. It is not, however, designed for continuous immersion in water.

The "dot-free" illumination (without visible light points) means the light strip delivers a perfectly uniform light output, with no individual LED points visible. This is achieved using a diffusion layer that blends the light from the LEDs, providing more uniform and aesthetically pleasing lighting than standard LED strips.

The Garmin LUX SNL180 LED strip integrates 180 LEDs per meter, contributing to its Superbright illumination and uniform light output.

Yes, the LED strip is designed to be flexible and adapt to curved surfaces. It has a minimum bending radius of 120mm, but it is crucial to bend it only along the lateral axis and not to twist or bend it along the vertical axis to avoid any damage.

Yes, the LED strip is made from a UV-resistant material. However, to optimize its lifespan and performance, it is recommended not to install it in areas exposed to direct strong sunlight.

No, it is imperative not to cut the LUX SNL180 light strip. It is supplied in factory-sealed prefabricated lengths to ensure compliance with IP67 standards. Any cutting would void these certifications as well as the product warranty.

The LED strip is installed using the provided stainless steel clips. These clips must be screwed in place with appropriate screws. Once the clips are secured, the flexible neon strip is simply pushed into place until an audible "click" confirms it is properly locked in. It is recommended to use multiple clips around tight curves to ensure good conformity and prevent the strip from lifting.

Yes, the LED strip can be bent laterally only, with a minimum bend radius of 120mm. It is critical not to bend it along the vertical axis or twist it, as this could damage the internal LEDs and void the warranty.

Yes, it is imperative to always ensure that the vessel’s power source and battery are disconnected or isolated before proceeding with any electrical installation to guarantee your safety and that of the system.

Yes, it is strongly recommended that a qualified professional performs the electrical and mechanical installation of the LED strip. This ensures correct, safe installation that complies with technical specifications.

To avoid damaging the tape, always unroll it carefully along its entire length and prevent it from falling or twisting. For lengths over one meter, it is recommended to use two people: one to install and another to hold and unroll the tape. Do not apply excessive pressure, pull, stretch, twist, or bend the tape on the vertical axis.

The LUX SNL180 light strip must be used exclusively with Lumishore’s dedicated LUX light strip modules. It is not compatible and must not be connected to other lighting control products or third-party controllers.

Yes, each LUX autopilot module is designed to handle up to 10 meters of total light strip length. If you need to install more than 10 meters, additional autopilot modules will be required.

Yes, using the LUX SNL180 light bar with third-party autopilots, other than Lumishore's dedicated light bar autopilot module, will void the product warranty.

Lumishore Ltd, the manufacturer, warrants its lighting systems and associated accessories against manufacturing defects for a period of three years from the original purchase date.

The warranty may be voided in case of misuse or abuse, incorrect installation or negligence, damage caused by disasters (fire, flood, storm, lightning), installation by unqualified personnel, unauthorized repair or modification, non-compliance with all installation, maintenance, and usage directives specified in the manual. Using third-party autopilots not approved by Lumishore will also void the warranty.