10x10 A DC digital switch

The DC 10x10A digital switch is a decentralized input/output module designed for MasterBus networks. It allows control of up to ten DC channels, such as lighting, pumps, or onboard electronics, with a 10 A capacity per channel.

No, this product is now obsolete. It is offered here as a spare part for maintenance and repair of existing marine electrical installations, avoiding the need to rewire the entire vessel.

This module operates within a voltage range of 8 to 30 V. It is therefore natively compatible with 12 V and 24 V battery banks.

Each individual output can handle 10 A. However, outputs can be wired in parallel to support higher currents, up to a total maximum of 100 A for the entire module.

Electrical safety is ensured by dual protection on each channel: a configurable software fuse at 10 A and a conventional hardware fuse at 15 A.

In case of network failure, a manual hardware reset (bypass) is possible directly on the device. The 15 A hardware fuses have positions allowing you to manually force the channels on or off.

Yes, the module includes ten built-in dimmers. This allows you to program the dimming of onboard lights directly from the system without needing to add external dimmers.

Also called "follow-me home" function, this is an automation that keeps the lights on for a short time after the switch is turned off, giving you time to leave the area safely.

For input connections, the module accepts cables up to 95 mm². For output connections, the maximum cable cross-section is 4 mm².

The switch has an IP21 protection rating. It is not waterproof and must be installed in a dry location, protected from rain, moisture, and condensation.

The module measures 40 x 229 x 110 mm (Height x Width x Depth) and weighs 0.75 kg. Its compact format makes it easy to integrate into the boat’s electrical panels.

No, its electrical consumption on the DC side is extremely low. It draws less than 2 mA when powered by 12 V or 24 V.

The device features a communication LED on the front panel. If it is lit continuously, the unit is operating normally. Different blinking patterns indicate power presence, an active alarm, or manual forcing of an output.

Yes, control and configuration are done via the MasterBus network. You will need a compatible display, such as the MasterView Easy, or the MasterAdjust software on a PC connected via a USB interface.

Yes, it is entirely possible to directly connect a standard switch (On/Off) to the switch to generate an electrical signal and control an output, without necessarily having to go through a digital display.

When a software fuse trips due to an overload, it can be easily reset remotely via the interface of your MasterBus display, without the need for physical intervention on the module.

Yes, the module includes smart alarm functions. It emits an alarm signal on the MasterBus network in case of overload detected on one of its channels.

Yes, power input connections can be directly linked to a MasterShunt or a Mastervolt DC Distribution system for optimal wiring management.

By using the hardware bypass, the input is directly connected to the output via the 15 A fuse. Caution: this cancels out software settings such as the dimmer. Additionally, raw input voltage will be applied to the connected device, requiring special attention if you have 12 V devices on a 24 V network.