Váltó Deckhand - 24 V DC 12 A

The BLUE SEA Deckhand 7509 dimmer is designed to digitally control the brightness of unregulated LED lights, incandescent and halogen bulbs in 24 V DC marine systems. It provides precise lighting management on board.

This dimmer can control the brightness of:

Unregulated LED lightsIncandescent bulbsHalogen bulbs

The Deckhand 7509 drive requires a nominal voltage of 24 V DC (direct current) to operate correctly.

The Deckhand 7509 drive can operate within a voltage range from 18 V to 32 V DC.

The maximum output current that the Deckhand 7509 drive can handle is 12 A.

The "bulb saver" function built into the Deckhand 7509 dimmer prevents premature aging of bulbs when the boat's batteries are being charged. This helps extend the lifespan of your bulbs.

The Deckhand 7509 drive has built-in overcurrent protection. If the device stops working due to an overcurrent, simply correct the excessive load, then hold the drive's switch pressed until the circuit flashes to reset it.

The Deckhand 7509 drive is designed to operate across a wide temperature range, from −40°C to 85°C.

The Deckhand 7509 dimmer uses Pulse Width Modulation (PWM) for light intensity control.

Yes, the Deckhand 7509 dimmer has a memory that stores the last used light intensity setting.

The maximum parasitic current of the Deckhand 7509 drive is less than 2 mA, indicating very low standby power consumption.

To activate the illuminated output mode and set the delay:

1-minute delay: Hold the switch in the high (illuminated) position for 2 seconds. The lights will flash. Release the switch after the first flash, and the lights will remain on for 1 minute. 2- to 5-minute delay: Hold the switch in the high (illuminated) position for 1 to 4 seconds after the first flash. Release the switch after 2 to 5 flashes. The lights will remain on for 1 minute per flash, up to a maximum of 5 minutes.

Yes, the Deckhand 7509 autopilot drive is supplied with a momentary (ON)-OFF-(ON) switch.

Yes, the offset mounting feet of the Deckhand 7509 autopilot are designed to allow multiple autopilots to be mounted close to each other, optimizing installation space.

If the variator stops working due to an overcurrent, you must first correct the excessive load. Then, hold down the variator switch until the circuit flashes to reset the built-in protection.

Yes, the Deckhand 7509 drive supports multiple switch locations, allowing it to be controlled from different points on your boat.

No, the Deckhand 7509 inverter is specifically designed for 24 V DC marine electrical systems and operates within a range of 18 V to 32 V. It is not compatible with 12 V DC systems.

No, the Deckhand 7509 dimmer is designed to digitally control the intensity of unregulated LEDs, as well as incandescent and halogen bulbs.

The Deckhand 7509 variable frequency drive complies with several regulatory standards, including:

E-markedISO 8846 (external ignition protection)SAE J1171 (external ignition protection)SAE J1455SAE J1113

Yes, the Deckhand 7509 variable speed drive complies with the external ignition protection requirements of ISO 8846 and SAE J1171 standards, ensuring its safety in marine environments.