30 hüvelykes ívelt fényszórósor

This curved LED bar has a length of 30 inches, which corresponds to approximately 749 mm (dimension E on the installation diagram).

It is designed for demanding marine applications and is optimized for installation on T-tops, helm roof tops, fishing towers, and bow platforms.

This light bar delivers a total of 53,460 lumens. The actual light output (fixture lumens) is 23,760 lumens.

Yes, the light is dimmable (adjustable intensity). It emits a white light with a color temperature of 5000 K, providing optimal clarity.

Yes, the beam angle is adjustable and can be set from 9 to 32 degrees, allowing precise focusing of the light according to your needs.

The housing is made of powder-coated aluminum and the lens is made of Makrolon. These materials provide the product with IP68-rated resistance, ensuring protection against water and dust in harsh marine environments.

The lifespan of LEDs is estimated at over 50,000 hours, ensuring a long period of reliable use.

The 30-inch LED light bar is equipped with 60 white LEDs, each with a power output of 10W.

This LED bar operates on a voltage range of 10.5 to 31 VDC.

The maximum electrical consumption for the 30-inch model is 19.3 A at 12 V and 9.7 A at 24 V.

You can control it in several ways:

Via a simple on/off switch.Via a multifunction display (MFD) using an LUX lighting control module.Via an ECLIPSE control center.

Yes, this LED bar is optimized for seamless integration within an existing Garmin ecosystem, providing powerful and coordinated lighting.

No, the ECLIPSE control unit is only suitable for boats operating on 12V. For other voltages, alternative control methods are available.

Yes, each lighting circuit must be properly fused to ensure safety and system protection.

This product must be installed, inspected and maintained only by a qualified electrician, in accordance with all applicable electrical codes.

The package includes the curved light bar, various lengths of M6 hex bolts, M6 flat washers, M6 nylon washers, M6 spring washers, M6 nylon insert nuts, two brackets, two flat plates, and two bracket drilling templates.

To avoid glare, position the light and adjust its angle so that no light falls on the bow of the boat. You can use a taut string from the bow to the top of the light to visualize the coverage area.

You will need to drill a 4 mm pilot hole, followed by a final diameter of 6.5 mm for the M6 mounting bolts.

Yes, it is strongly recommended to use a marine sealant (such as 3M 4200) inside and around mounting holes, as well as to seal the cable entry. Using a cable gland for the cable is also advised.

Yes, if an adjustment of the light tilt is required after installation, it is important to loosen ALL bolts (those on the brackets and those securing the brackets to the boat) before making the adjustment, then retighten them to the recommended torque (8Nm for the side bolts of the brackets).