GT56UHD-TH merülőfejes – UHD ClearVü/SideVü

Yes, the Garmin GT56UHD-TH transducer is designed to be compatible with Garmin chartplotters. However, it is essential to update your Garmin chartplotter’s software when installing this transducer to ensure compatibility and optimal performance. Update instructions are typically found in your chartplotter’s user manual on support.garmin.com.

Anti-rotation bolts are crucial for the safety and performance of the GT56UHD-TH fishfinder. They are included with the device and must be installed to prevent the transducer from rotating when the boat is in motion. Failure to install them could result in damage to your vessel and compromise the reliability of sonar readings by altering the transducer's orientation.

The choice of location is essential for optimal performance and must be done carefully. Here are the main considerations:

Non-turbulent water: The transducer must be installed in an area where the water is clean, free of air bubbles and turbulence caused by strakes, reinforcements, fittings, through-hulls, or water discharges.

Engine/propeller distance:
- Outboard and sterndrive boats: in front of and near the engine(s).
- Inboard boats: in front of and away from the propeller and propeller shaft.
- Single-screw boats: do not install in the propeller wash to avoid cavitation.
- Twin-screw boats: if possible, between the propellers.

Specific hull types:
- Planing hulls: in front of the first chine.
- Full-keel hulls: slightly angled toward the bow, parallel to the centerline.
- Shoal-draft keel hulls: 25 to 75 cm ahead of the keel and max 10 cm to the side of the centerline.
- Displacement hulls: about 1/3 of the waterline length from the bow, and 150 to 300 mm to the side of the centerline.

Avoid impacts: Do not install in a location where it could be struck during launching, beaching, or storage.

The transducer must be installed parallel to the fore-aft axis of your vessel.

A fairing block is an accessory that allows you to position the transducer parallel to the waterline, improving the accuracy of sonar data. You must measure the deadrise angle of your boat's hull at the installation location. If this angle exceeds 5°, using a fairing block is recommended for optimal transducer mounting.

The hole sizes to drill in the hull vary slightly depending on the hull type:

For the central hole of the tiller (stem hole):
Fiberglass hulls (with or without core): 25 mm (1 inch) diameter.
Metal hulls: 32 mm (1 1/4 inch) diameter.

For the anti-rotation bolt holes:
Fiberglass hulls (with or without core): 9 mm (3/8 inch) diameter.
Metal hulls: 13 mm (1/2 inch) diameter.

It is recommended to use the mounting template provided in the product box to precisely mark the hole locations.

The main advantage of a through-hull transducer like the Garmin GT56UHD-TH is its ability to provide optimal and reliable sonar readings. By being installed directly through the hull, it sits in clean, non-turbulent water, minimizing interference and ensuring better sonar image clarity and accuracy. This is particularly beneficial for ultra-high-definition scanning functions.

For the installation of the GT56UHD-TH transducer, it is recommended to use a flexible and fast-curing marine sealant specifically designed for below-waterline applications. This type of sealant ensures a solid and durable watertight seal between the transducer (or the fairing block, if used) and the hull of your boat, preventing water infiltration.