Garmin GMR Fantom 5x radarállvány, felső rész

For optimal performance and safety, consider the following points when choosing the mounting location:

The radar must be mounted out of reach of people, with the vertical beam width above head height. It must be mounted high above the vessel’s keel line, with minimal obstruction of the radar beam. The mounting surface must be flat, parallel to the vessel’s waterline, and strong enough to support the radar’s weight. The radar must be mounted where power, ground, and network connections can be made. Avoid mounting the radar near heat sources (exhausts, lights) or at the same height as horizontal spreaders or mast crossbars. Other electronic equipment and cables must be more than 2 meters (6.5 feet) from the radar beam path. GPS antennas must be either above or below the radar beam path. Maintain a distance of at least 1 meter (40 inches) from any transmitting equipment and cables carrying radio signals (VHF). Maintain a distance of at least 2 meters (6.5 feet) from SSB radios (single sideband).

For the radar pedestal installation, you will need the following tools:

A Phillips screwdriver size #2
A 6 mm hex key
A drill
A 15 mm (19/32 in) drill bit
A 32 mm (1 1/4 in) drill bit (optional, for cable routing)
A 17 mm (21/32 in) wrench and a torque wrench
12 AWG (3.31 mm²) copper wire for grounding the radar housing and voltage converter (if applicable)
Marine sealant

Yes, the radar (and the voltage converter, if applicable) must be connected to a dedicated underwater ground. A 3.31 mm² (12 AWG) copper wire (not included) is required. This wire must be routed to an underwater grounding point and connected to the ground connector on the pedestal. After connection, the ground screw and crimp connector must be coated with marine sealant.

The radar transmits electromagnetic energy. To avoid injury, ensure all persons are clear of the radar beam path before transmitting.
Do not look directly at the antenna up close while the radar is transmitting, as the eyes are the most sensitive part of the body to electromagnetic energy.
Do not remove the built-in fuse from the power cable. The correct fuse must be in place to prevent fire or overheating risks.
Installation by a qualified marine technician is recommended for optimal performance and to avoid damaging the device or the vessel.
Never open the device yourself, as it contains no user-serviceable parts and must only be opened by an authorized Garmin service technician.
Use the device solely as a navigation aid.
Always wear safety glasses, hearing protection, and a dust mask when drilling, cutting, or sanding.

No, it is strongly advised not to open the GMR Fantom 5x radar pedestal yourself. The unit contains no user-serviceable parts and must only be opened by a Garmin authorized service technician. Any damage resulting from opening the unit by someone other than a Garmin authorized service technician will not be covered under the Garmin warranty. Additionally, the radar contains high voltages and generates non-ionizing radiation, which poses a risk of serious injury or death.

To mount the antenna on the pedestal:

Remove the protective cover from the waveguide located on top of the pedestal. Align the pedestal’s waveguide with the socket under the antenna, then slide the antenna onto the pedestal. Secure the antenna to the pedestal by tightening the captive hex bolts located under the antenna arm. Tighten the hex bolts to a torque of 7.9 N·m (6 lbf·ft) to firmly secure the antenna without damaging it or the mounting hardware.