Dławik CableClam z osłoną wykończeniową ze stali nierdzewnej 1.40"

This CableClam is designed to accommodate cables with a maximum diameter of 1.40 inches (approximately 35.57 mm). The rubber gasket can be adjusted to ensure optimal sealing around the cable.

The decorative cap of this CableClam is made of stainless steel. This material ensures an aesthetic finish, increased durability and excellent corrosion resistance, particularly suited to marine environments.

Once installed, the CableClam with its decorative stainless steel cap has the following dimensions:

Cable passage diameter: 1.40 inches (35.57 mm)
Total height (with cap): 1.02 inches (25.86 mm)
Total width (with cap): 2.77 inches (70.48 mm)

To ensure optimal watertightness, the CableClam is fitted with a rubber gasket. Here are the key steps for sealing:

Check if the pre-punched rubber gasket provides a tight fit around your cable. If necessary, drill a hole in the gasket that ensures a tight fit with the cable, then slit the gasket from the edge to the drilled hole.Insert the cable through the slit in the gasket and press the gasket into the compression ring.Tighten the compression ring onto the deck ring without over-tightening the screws to avoid damaging the components.

The CableClam is designed to be mounted using #8 screws. These screws are usually not included and must be supplied separately.

Yes, the rubber gasket supplied with the CableClam is designed to be adjustable. It can be drilled or trimmed by the user to fit the exact diameter of the cable you intend to pass through, ensuring optimal watertightness.

Yes, this CableClam is specifically designed for marine applications and offers increased resistance to UV and salt corrosion. Its stainless steel cap also contributes to its durability and resistance in demanding marine environments.

Installing the CableClam involves several key steps to ensure a secure and watertight fit:

Prepare the rubber gasket by drilling or trimming if necessary, then slit it from the edge to the hole.Attach the deck ring and its gasket to the mounting surface.Thread the cable end through the stainless steel cap.Slide the compression ring onto the cable, insert the cable through the slit in the gasket, then press the gasket into the compression ring.Tighten the compression ring to the deck ring by progressively tightening each screw, without over-tightening.Finally, press the stainless steel cap onto the assembly for a clean finish.