Wyłącznik baterii selektor HD-Series wzmocniony

The Blue Sea Systems HD-Series 3002-BSS battery selector switch has a continuous current capacity of 500 amperes. This capacity is suitable for large diesel engines and high-consumption systems.

This battery switch has a cranking rating of 1,600 amperes for 30 seconds and an intermittent rating of 700 amperes for 5 minutes.

The maximum operating voltage supported by the Blue Sea Systems HD-Series battery selector is 32 V DC.

The selector uses M12-1.75 (1/2") tinned copper studs. These studs are 22.22 mm (7/8") long and are designed for maximum conductivity and high corrosion resistance.

The recommended tightening torque for the connection bolts is 24.86 N·m (220 in-lb).

The HD-Series battery selector switch is designed to accept battery cables with a cross-section of 4/0 AWG (120 mm²).

The 3002-BSS selector box housing is designed for versatile mounting, either on the surface or on the rear panel.

Yes, this battery selector switch is protected against external ignition. It complies with UL 1500 and SAE J1171 standards, making it safe for installation on gasoline-powered boats.

The Blue Sea Systems HD-Series battery selector switch is IP66 certified, providing protection against dust and powerful water jets.

This selector allows choosing between battery bank 1, battery bank 2, or the combined 1+2 setup. It is used for charging or emergency starting.

Yes, it is imperative to disconnect the battery's positive terminal before proceeding with the installation of the selector.

The selector must be installed in an easily accessible location close to the batteries for optimal installation and practical use.

To meet the assigned value, a 120 mm² (4/0 AWG) cable must be connected to each battery terminal and two 120 mm² (4/0 AWG) cables to the common terminal. Cable lugs must be secured under the nut.

This selector features a "Make-Before-Break" contact design. It allows switching between battery banks without interrupting power to the equipment, ensuring continuous service.

This selector fully complies with American Boat and Yacht Council (ABYC) requirements for battery switches, is UL 1107 listed for electrical power switches, and meets UL 1500 and SAE J1171 standards for external ignition protection. It is also IP66 certified.

No, it is crucial not to set the selector to OFF when the engine is running to avoid damaging the electrical system.

Before turning the battery selector switch to the OFF position, it is recommended to turn off all connected electrical devices.

Yes, with its continuous capacity of 500 amperes, the HD-Series selector is specifically suited for large diesel engines and marine systems with high power consumption.

Blue Sea Systems offers a satisfaction guarantee. Any Blue Sea Systems product a customer is not satisfied with can be returned for a refund or replacement at any time.

The HD-Series has a continuous capacity of 500 amps. By comparison, the m-Series range has a continuous capacity of 300 amps and the e-Series range has a continuous capacity of 350 amps.