ECLIPSE SNL100, neonowy pasek Neon Flex, 1 m

The GARMIN ECLIPSE SNL100, Neon Flex Light, is a 1-metre flexible LED lighting solution designed specifically for marine applications. It provides continuous illumination without visible hotspots and is suitable for both indoor and outdoor environments.

Yes, this LED light strip is fully sealed with an IP68 rating, protecting it against dust and temporary immersion. It can be installed indoors or outdoors, including in wet areas, but is not designed for permanent submersion in water.

The GARMIN ECLIPSE SNL100 LED light strip consumes approximately 6 watts per meter.

The LED strip is made from UV-resistant material, ensuring durability even when exposed to sunlight. However, it is recommended not to install it in areas of strong direct sunlight.

The GARMIN ECLIPSE SNL100 is designed to provide continuous and uniform illumination, with no visible light spots, thanks to its 120 RGB LEDs per meter.

The GARMIN ECLIPSE SNL100 light bar has a length of one meter (1M).

The light strip has a width of 16 mm and a height of 22 mm.

Yes, this model can be cut to custom lengths in 25 mm increments thanks to its 'cut-and-seal' design. It is imperative to cut only at the marked cut points and to use the provided sealing kit to ensure waterproofing.

It is important to carefully unroll the Neon Flex along its entire length and let it relax for about an hour before installation. Do not drop it, twist it, or apply excessive pressure. It is recommended to use two people to install lengths over one meter.

The light strip features a 'bend-flex' design that allows it to follow the contours of curved surfaces. It has a minimum bending radius of 120 mm on the vertical axis (meaning it bends along its widest face). It is critical not to bend it on the horizontal axis (along its narrowest edge) or twist it to preserve its structural integrity.

Yes, it is crucial to always ensure that the vessel's power source and battery are disconnected or isolated before proceeding with installation. It is also strongly recommended that a qualified professional performs the electrical and mechanical installation.

Although the Neon Flex is UV-resistant, it must not be installed in areas exposed to strong direct sunlight. Additionally, while it can be installed in damp areas, it is not designed to be permanently submerged in water.

Yes, it is strongly recommended that a qualified professional carry out the electrical and mechanical installation of the LED strip to ensure correct and safe installation.

After cutting the light strip at a marked cut point, you must use the provided sealing kit. It is recommended to wrap the Neon Flex during this process to retract the printed circuit board (PCB), which will prevent the sealant from covering the LEDs and avoid their discoloration.

Yes, you must fully unroll the Neon Flex from the spool and let it relax flat for at least one hour before installation. Do not allow it to bend, twist, or bunch up.

Yes, it is recommended to use two people to install Neon Flex strips longer than one meter: one person to handle the installation and another to hold and unroll the light strip.

The GARMIN ECLIPSE SNL100 is designed to operate only with 12V DC boat systems. It can operate within a voltage range of 10 to 15V DC.

No, it is essential not to connect the GARMIN ECLIPSE SNL100 to voltages outside the 10-15V DC range, nor to connect it directly to AC voltage (alternating current).

Yes, the RGB version of Neon Flex MUST be used in conjunction with an ECLIPSE Command Center and optional extension modules for operation and control.

No, it is important not to add monochrome, bicolor, and RGB lights to the same Command Center zone output. You must use a separate zone output for each type of lighting.