LUX SL180, pasek LED, CRGBW, 1000 mm

The Garmin LUX SL180 light bar has a length of 1000 mm (1 meter).

The LUX SL180 light strip is a CRGBW lighting solution, meaning it can produce cold white, red, green, blue, and warm white colors.

Yes, the white temperature is adjustable from 2700 K (warm white) to 6500 K (cool white), allowing you to create the desired ambiance on board.

Yes, the Garmin LUX SL180 LED light bar is specifically designed for marine ambient lighting. It is fully encapsulated and factory-sealed to meet IP68 standards, making it resistant to dust and water for use above the waterline. Its UV-resistant material construction and compliance with salt fog testing ensure durability in marine conditions.

The LUX SL180 LED light strip has a nominal power consumption of 5 watts per meter. For a 1000mm strip, the total consumption is therefore 5 watts.

The Garmin LUX SL180 light strip has a discreet profile of approximately 5 mm in depth and 14.5 mm in height, making it easy to integrate into various spaces.

The LED strip is fully sealed and meets the IP68 standard, making it resistant to dust and water. It can be installed in damp areas or outdoors, but it is not designed for permanent submersion in water.

No, the LED strip is supplied in ready-to-use lengths and is factory-sealed to meet IP68 standards. It is imperative not to cut the LED strip, as this would void the warranty and compromise its waterproofing.

The light strip is equipped with a 3M adhesive layer for easy installation. For outdoor installations in wet areas or with tight radii of curvature, it is recommended to use mechanical fastenings in addition to the adhesive. Fixation clips can be used every 25 to 30 cm or on each side of a bend.

The LED strip has a minimum bending radius of 50 mm only in the vertical axis. It is critical not to bend it in the horizontal axis or twist it, as this could damage it.

Although the LED strip is made from UV-resistant materials, it must not be installed in areas exposed to strong direct sunlight. Additionally, avoid bending it along the horizontal axis or twisting it.

Yes, a qualified professional should perform the electrical and mechanical installation of the LED strip to ensure correct and safe installation.

Before any installation, always ensure the boat's power source and battery are disconnected or isolated for safety reasons.

After firmly pressing the light strip into place with 3M adhesive, it is recommended to allow the adhesive to set for 24 hours before turning on the light strip.

The Garmin LUX SL180 light strip requires a dedicated Lumishore LUX Strip Light driver module to operate. It is designed to be used exclusively with these modules.

No, the LUX SL180 light strip is designed to work only with Lumishore LUX Strip Light driver modules. Connection to third-party lighting control products or drivers is not supported and will void the warranty.

The LED strip operates within a voltage range of 23 to 25V when connected to the dedicated Lumishore LUX Strip Light driver module.

LUMISHORE Ltd guarantees its lighting systems and associated accessories against manufacturing defects for a period of three years from the original purchase date.

The warranty may be voided in case of misuse, abuse, incorrect installation, negligence, damage caused by disasters, installation by unqualified personnel, unauthorized repair or modification, or unapproved installations. Failure to comply with the installation, maintenance, and usage guidelines in the installation document also constitutes a breach of warranty conditions, as does use with third-party drivers.

The Garmin LUX SL180 light bar is supplied in a pre-cut and factory-sealed length with integrated 3M adhesive. Mechanical mounting clips, while recommended for certain installations, are optional accessories and not included by default.