LUX SL180, pasek LED, CRGBW, 2500 mm

The LUX SL180 LED strip provides CRGBW lighting, meaning it can produce cold white, red, green, blue, and warm white colors. It also allows for tunable white, ranging from warm white (2700K) to cool white (6500K).

The LUX SL180 LED light strip has a length of 2500mm.

Yes, the LUX SL180 is specifically designed for the marine environment. It features fully encapsulated construction, UV resistance, and has been tested for salt spray to ensure durability in outdoor conditions.

The LUX SL180 LED strip has an IP68 protection rating. This ensures full protection against dust and temporary immersion in water.

No, although the LUX SL180 band is rated IP68 and can be installed in wet areas, it is not designed for continuous submersion in water.

The LUX SL180 LED light strip is equipped with 180 CRGBW LEDs per meter, ensuring uniform light distribution.

Yes, the LUX SL180 strip offers tunable white lighting that can be adjusted from 2700K (warm white) to 6500K (cool white), allowing precise adaptation of the lighting atmosphere.

The LUX SL180 LED strip requires a connection to the Lumishore LUX Strip Light Driver module to operate. This module can support up to 10 meters of LED strip per driver.

No, the LUX SL180 strip is designed for use exclusively with Lumishore LUX Strip Light Driver modules. Using third-party control gear or drivers is not recommended and may void the warranty.

The LUX SL180 light strip operates with an input voltage of 23 to 25V, supplied by the Lumishore LUX Strip Light Driver module. The driver module itself accepts an operating voltage of 10.5–31 VDC.

No, the LUX SL180 LED strip is supplied in ready-to-use lengths sealed at the factory to meet IP68 standards. Cutting the LED strip is strictly prohibited.

Before installation, it is essential to thoroughly clean the mounting surface with isopropyl alcohol (IPA) to ensure it is free of dust and dirt.

The light strip has a minimum bending radius of 50mm and must only be bent along its vertical axis. Do not bend it along the horizontal axis or twist it.

Yes, for outdoor installations, in wet areas or for tight bend radii, it is strongly recommended to use mechanical fasteners in addition to the adhesive layer.

Mechanical fasteners must be placed every 25 to 30 cm, and/or on each side of a bend.

Do not let the strip fall or twist. Unroll it carefully from the spool. Do not apply pressure on the LED area, only on the edges of the strip. Do not pull, stretch, twist, or bend the strip along the horizontal axis. For lengths over one meter, it is advisable to use two people.

Yes, always ensure the boat’s power source and battery are disconnected or isolated before proceeding with the installation.

It is recommended to let the adhesive set for 24 hours after installation before turning on the light strip.

The warranty may be voided in case of misuse, incorrect installation, negligence, damage caused by disasters (fire, flood, lightning), installation by unqualified personnel, unauthorized repair or modification, or unapproved installations. Failure to comply with installation guidelines and usage instructions, including use with third-party drivers, also constitutes non-compliance with warranty terms.