Zestaw VHF stacjonarny GMDSS GM600 24V

The Icom GM600 fixed VHF is certified MED (Marine Equipment Directive) and SOLAS. It also complies with international IMO and IEC standards, ensuring absolute reliability for distress and safety communications at sea.

This radio communication equipment is designed and certified to ensure the safety of vessels operating in maritime zones A1 and A2 under the Global Maritime Distress and Safety System (GMDSS).

The GM600 VHF delivers a maximum RF output power of 25 W for long-range communications. It can also be switched to 1 W for short-range exchanges, saving power and reducing interference.

Yes, the front panel of the GM600 VHF radio has IPX7 protection. This means it is fully waterproof against water splashes and can withstand temporary immersion up to 1 meter deep for 30 minutes.

The GM600 VHF is a compact unit designed to integrate easily into your helm station. Its overall dimensions are 274 × 114 × 121.5 mm and it weighs approximately 1.6 kg.

Yes, the pack includes the HM-214V handheld microphone. Like the radio’s front panel, this microphone is waterproof certified to IPX7 standard for safe use even in wet conditions.

This specific pack is designed for direct 24 V DC power supply, with a tolerance range from 21.6 to 31.2 V. The device can also operate on a 12 V DC network (10.8 to 15.6 V) depending on your vessel's configuration.

Absolutely. The GM600 VHF integrates a Class A DSC (Digital Selective Calling) receiver. It uses Channel 70 (156.525 MHz), which is permanently dedicated to distress alert monitoring and transmission.

Integration with navigation instruments is done via a standardized IEC 61162-1 interface. Simply connect the corresponding data wires so the VHF receives the vessel's exact position in real time.

For receiving positioning data, the VHF interface accepts NMEA sentences in RMC, GGA, GNS, GLL, and VTG formats.

The GM600 VHF transmits Digital Selective Calling (DSC) data to other onboard equipment using DSC and DSE output sentences.

Yes, it is entirely possible to connect an external speaker. The radio has excellent amplification capability, delivering 10 W of audio power to an external 4 Ω speaker.

If you are not using an external speaker, the GM600 VHF’s internal speaker delivers clear 2 W audio output, which is more than sufficient for a standard bridge environment.

The VHF covers the standard marine frequency range. Transmission (Tx) operates from 156.025 to 161.600 MHz, while reception (Rx) covers 156.025 to 162.000 MHz.

The VHF can be installed in two ways: either mounted on a bracket, or flush-mounted directly into the chart table console for a professional finish and optimal space savings.

The device must be connected to the vessel's 24V battery bank using a DC power cable with an appropriate cross-section to handle a peak current of approximately 3.3 A during full-power transmission.

Yes, the GM600 VHF connects to any standard marine VHF antenna operating in the 156 MHz band with a 50-ohm impedance. The connection is made via the antenna port located at the rear of the unit.

Yes, thanks to its SOLAS and MED certifications (steering wheel), the GM600 VHF perfectly meets the mandatory equipment requirements for passenger ships and cargo ships of 500 GT (UMS) or more subject to the SOLAS convention.