Przetwornica-ładowarka Magic 24/12 - 20A

The Magic 24/12 - 20A is a versatile device that primarily converts a 24V DC voltage into a stabilized 12V voltage. It can also be used as a 3-stage battery charger or as a dimmer for your lighting.

Yes, this model provides full galvanic isolation between input and output. This protects sensitive electronic equipment, such as communication or transmission gear, from electrical interference.

When configured in charger mode, it is compatible with a wide range of 12V batteries, including:

Flooded lead-acid (wet)GelAGMSpiral cellTractionLithium-Ion

The converter delivers a nominal and maximum output power of 300 W, with a maximum output current of 20 A (or 16 A when used in battery charger mode).

Yes, it is entirely possible to configure multiple converters in parallel. This feature is ideal if you have many consumers on board, as it allows you to achieve capacities exceeding 100 amps.

To ensure a secure installation, the screw terminal on the device is designed to accept cables with a maximum cross-section of 16 mm² (AWG5).

The dimmer function allows you to efficiently regulate the intensity of your 12V lighting without energy loss as heat. It is activated using an external momentary switch and requires specific adjustment of the internal DIP switches.

It is recommended to install it in a well-ventilated area, protected from rain, moisture, and dust. Mount it in a vertical position with cables facing downward. Caution: never install it directly above batteries to avoid damage from corrosive fumes.

Yes, although it does not have a native MasterBus port, it is compatible and can be integrated into your network via a MasterBus serial interface available as an option.

Yes, the nominal output voltage is 13.6 V, but it can be precisely adjusted between 10 V and 15 V using a PC and the MasterAdjust software.

The converter has an IP21 protection rating. It is therefore protected against vertically falling water droplets, but it must be installed indoors in a dry environment.

You have two methods for configuration:

Use the 4 DIP switches located inside the housing for basic settings. Program it in advanced mode via a computer using the MasterAdjust software.

The device uses high-frequency switching technology, delivering excellent efficiency above 90% at full load, with peaks reaching 92%.

Yes, it is equipped with automatic overload and overheating protections. Additionally, its cooling is provided by silent, low-maintenance variable-speed fans.

Voltage range depends on the mode of use:

In standard converter mode: 19 to 32 V.In 3-stage battery charger mode: 24 to 32 V.

Yes, for safety reasons, it is essential to install a fuse on the positive cable. This fuse must be placed as close as possible to the source battery.

When configured to charge a 12V battery (3-stage smart charging mode), the device delivers a maximum charging current of 16 A.

This converter is compact and lightweight. It measures 227 x 154 x 81 mm (Height x Width x Depth) and weighs 1.8 kg in total.

No, if your goal is to use it as a simple 13.6 V stabilized power supply, the factory settings are perfectly suitable and you do not need to adjust the DIP switches.

Warning: the device has an internal non-replaceable input fuse. Reverse polarity (swapping positive and negative wires) will irreparably damage the converter. Always check your connections before powering on.