ST60+ Płytka drukowana WIND PCB/DIAL ASSY

This is the main circuit board paired with the dial assembly, specifically designed for the Raymarine ST60+ Wind anemometer display.

This component resolves common faults such as:

Analog needle malfunction or freezing. LCD display issues. Loss of communication with the network or wind sensor.

Yes, part number A28004-P includes both the printed circuit board (PCB) and the dial assembly (DIAL ASSY) for the ST60+ Wind instrument.

Absolutely, this is an original Raymarine spare part, which guarantees the same quality and reliability as your initial equipment.

Yes, this part is designed for ST60 displays. The printed circuit boards of the ST60 and ST60+ generations share the same internal design; differences are mainly cosmetic.

No, each type of instrument has its own electronic circuit board. This model is exclusively for the ST60+ Wind display (anemometer and vane).

Replacement requires opening the housing and handling sensitive electronic components. While it can be done yourself, it is strongly recommended to have it performed by a qualified technician to avoid damaging the part.

When reassembling your ST60+ Wind display, it is critical to check the condition of the housing's waterproof gasket. If it is worn, it must be replaced, and the screws must be tightened evenly to prevent water ingress.

Yes, as you are replacing the electronic core of the display, you will need to recalibrate your wind transducer / vane anemometer (apparent wind alignment and alarm settings) by following your ST60+ manual.

Yes, if the LCD screen of your ST60+ Wind instrument is unreadable, damaged, or leaking liquid crystals (black spots), replacing this complete assembly (PCB + dial with screen) will resolve the issue.

Yes, the printed circuit board includes the necessary components to ensure bidirectional communication via the SeaTalk 1 network used by Raymarine instruments of this generation.

The ST60+ range has not been manufactured by Raymarine for several years. Spare parts such as this circuit board are therefore classified as obsolete, and their availability is limited to the last remaining stocks on the market.

The assembly includes the dial mechanism (DIAL ASSY), but you will generally need to carefully remove and reinstall the physical needle from your old display onto the new mechanism.

Yes, the printed circuit board handles all display functions, including power supply and control of the LCD screen and analog dial backlighting.

Unscrew the rear housing, carefully disconnect the ribbon cables (do not pull sharply) and remove the PCB retaining screws. Work on a clean surface free of static electricity.

No, this circuit is programmed to specifically interpret the analog signals from Raymarine masthead wind sensors compatible with the ST60/ST60+ series.

You will mainly need small precision crosshead screwdrivers to open the housing and detach the PCB. A precision tweezers can also be useful for handling the small internal connection ribbons.

Yes. Replacing only the faulty circuit in your ST60+ Wind Wind transducer allows you to preserve your current installation, maintaining the same aesthetics and SeaTalk compatibility without needing to invest in a next-generation system.

If the needle is offset, you must perform the wind transducer alignment procedure (linearization) detailed in the Raymarine ST60+ Wind user manual, typically by sailing head-to-wind.

The printed circuit board is factory-treated (tropicalizing varnish) to resist marine environments. However, it is the integrity of the display housing and its gasket that ensures the true waterproofing of the entire unit.