Gniazdo USB-C podwójne Flip Pro Max

Required hole diameter is 32 mm (1 1/4 inch). Use a 32 mm hole saw to drill the hole in the panel. Installation is only possible from the front of the panel.

Panel thickness must be between 3 mm (0.11 in) minimum and 25 mm (1 in) maximum. This range allows secure installation on most boat dashboards.

Yes, in addition to the 32 mm hole, you must drill two pilot holes for the front ring mounting. The drill bit size depends on the material: 2.5 mm (3/32 in) for soft materials like plywood, and 3 mm (1/8 in) for hard materials like fiberglass.

Required tools: a 32 mm (1 1/4 inch) hole saw, a drill, a 2.5 mm or 3 mm drill bit depending on the material, a Pozidriv screwdriver, and silicone sealant to ensure watertightness of the fittings.

To ensure IPX4 waterproofing at the front, apply silicone to the fasteners and pilot holes before installing the front ring. Ensure the mounting surface is perfectly flat, smooth, and non-porous. The supplied gasket must be correctly positioned between the housing and the panel.

The socket accepts an input voltage from 10 to 32 V DC, making it compatible with 12 V and 24 V electrical systems found on boats. It can therefore be used in most marine installations.

On a 12 V system, the USB-C port delivers up to 36 W with the following profiles: 5 V⎓3 A, 9 V⎓3 A, and 12 V⎓3 A maximum. This allows for fast charging of compatible smartphones and tablets.

On a 24 V system, the USB-C output delivers up to 60 W with the following profiles: 5 V⎓3 A, 9 V⎓3 A, 12 V⎓3 A, 15 V⎓3 A, and 20 V⎓3 A maximum. This allows fast charging of more demanding devices such as laptops.

Yes, the socket is specifically designed to charge devices compatible with Quick Charge (QC) and Power Delivery (PD). It automatically negotiates the best charging profile with the connected device, within its capabilities.

Standby power consumption is less than 0.1 W, with a typical value of just 0.01 W. This ensures minimal discharge of the boat's battery when the device is not in use.

The ingress protection rating is IPX4 on the front panel, meaning it is protected against water splashes from all directions. This protection is only valid if the installation is carried out correctly according to the instructions.

No, this product is not approved for use in hazardous or flammable atmospheres, such as an engine room. Do not install it in such areas. Choose a well-ventilated location away from heat sources.

The wire gauge and fuse rating depend on the input voltage and the maximum current of 6 A. For a professional installation, it is recommended to consult an electrician. Use an appropriate fuse or circuit breaker between the battery and the product.

This is normal: the product has a safety feature that may temporarily shut it down in case of high ambient temperature or direct sun exposure. Avoid installing it in areas exposed to thermal radiation or with poor ventilation.

Yes, if your laptop is USB-C Power Delivery compatible and you are on a 24 V system, the socket can deliver up to 60 W (20 V⎓3 A), which is sufficient for many laptops. On a 12 V system, the maximum power is 36 W.

Yes, the installation instructions include a 1:1 scale drilling template. This template allows you to mark the exact location of the 32 mm hole and pilot holes before drilling.