GPSMAP® 8416 - ecran traceur 16"

The Garmin GPSMAP 8416 is equipped with a 16-inch touchscreen. It is part of the GPSMAP 8400/8600 series, known for its comprehensive integration capabilities for marine navigation and monitoring systems.

The GPSMAP 8416 offers extended network integration capabilities. It supports the following connections:

Garmin Marine NetworkNMEA 2000NMEA 0183HDMI (input and output)J1939Wi-FiANT

Yes, the GPSMAP 8416 is compatible with FLIR marine cameras, including the FLIR M and MD series. FLIR IP cameras are "plug-and-play" on the Garmin Marine Network, meaning they are automatically detected and accessible without additional configuration. For older analog FLIR cameras, manual pairing with a video input device is required.

For a flush mount installation, the required cutout dimensions for the GPSMAP 8416 are 374.8 mm (14 3/4 in.) in width and 234.1 mm (9 3/16 in.) in height. Garmin recommends using the mounting template provided with the product to ensure precise cutting.

To connect standard Ethernet devices, including third-party network cameras, to the Garmin Marine Network, you must use a Garmin Power over Ethernet (PoE) isolation coupler (part number 010-10580-10). Using a shielded cable, such as a CAT 5e F/FTP, is recommended for better protection of your equipment. It is important not to connect a PoE device directly to a Garmin Marine Network chartplotter, as this could damage the device.

Yes, the GPSMAP 8416 supports the Camera Tracking function. To use this function, you must connect the following equipment via the Garmin Marine Network or the NMEA 2000 network:

A marine camera compatible with tracking (e.g., a recent-model FLIR IP video camera).A GPS antenna.A heading sensor (a 9-axis sensor providing yaw, pitch, and roll data is recommended for optimal performance).For AIS or MARPA target tracking, a compatible AIS receiver or a compatible radar device is also required.

Yes, it is recommended to install a ferrite bead on the power cable and on each network cable. If the device is equipped with a fishfinder, a ferrite bead should also be installed on each transducer cable.

You can update the software of your GPSMAP 8416 using an SD card (16 to 32 GB, formatted as FAT32) and the Garmin Express application.

The general procedure is as follows:

Insert an SD card into your computer’s card reader.Install the Garmin Express application.Select your boat and device in the application.Select "Software Updates" then "Continue".Read and accept the terms.Select the drive corresponding to your SD card.Once the files are copied to the SD card, eject it from the computer.Turn on the chartplotter and wait for the home screen to appear.Insert the SD card into the GPSMAP 8416’s card reader.Select "Update Software" then "Yes".The device will restart once the update is complete.