LUX SL180, bandă LED, CRGBW, 1000mm

The Garmin LUX SL180 light bar has a length of 1000 mm (1 meter).

The LUX SL180 light strip is a CRGBW lighting solution, meaning it can produce cold white, red, green, blue, and warm white colors.

Yes, the white temperature is adjustable from 2700 K (warm white) to 6500 K (cool white), allowing you to create the desired onboard ambiance.

Yes, the Garmin LUX SL180 LED strip is specifically designed for marine ambient lighting. It is fully encapsulated and factory-sealed to meet IP68 standards, making it dustproof and waterproof for use above the waterline. Its UV-resistant material construction and salt fog testing compliance ensure durability in marine conditions.

The LUX SL180 LED strip has a nominal power rating of 5 watts per meter. For a 1000mm strip, the total power consumption is therefore 5 watts.

The Garmin LUX SL180 light strip features a discreet profile of approximately 5 mm depth and 14.5 mm height, making it easy to integrate into various spaces.

The light strip is fully sealed and meets IP68 standards, making it resistant to dust and water. It can be installed in damp areas or outdoors, but it is not designed for permanent submersion in water.

No, the LED strip is supplied in ready-to-use lengths and is factory-sealed to meet IP68 standards. It is imperative not to cut the LED strip, as this would void the warranty and compromise its waterproofing.

The LED strip comes with a 3M adhesive backing for easy installation. For outdoor installations in wet areas or with tight bends, it is recommended to use mechanical fasteners in addition to the adhesive. Fixation clips can be used every 25 to 30 cm or on each side of a bend.

The LED strip has a minimum bending radius of 50 mm in the vertical axis only. It must not be bent in the horizontal axis or twisted, as this could damage it.

Although the LED strip is made from UV-resistant materials, it must not be installed in areas exposed to strong direct sunlight. Additionally, avoid bending it along the horizontal axis or twisting it.

Yes, a qualified professional should carry out the electrical and mechanical installation of the LED strip to ensure proper and safe installation.

Before any installation, always ensure the boat's power source and battery are disconnected or isolated for safety reasons.

After firmly pressing the light strip into place with the 3M adhesive, it is recommended to allow the adhesive to set for 24 hours before turning on the light strip.

The Garmin LUX SL180 LED strip requires a dedicated Lumishore LUX Strip Light driver module to operate. It is designed to be used exclusively with these modules.

No, the LUX SL180 LED strip is designed to operate exclusively with Lumishore LUX Strip Light driver modules. Connection to third-party lighting control products or drivers is not supported and will void the warranty.

The LED strip operates within a voltage range of 23 to 25V when connected to the dedicated Lumishore LUX Strip Light driver module.

LUMISHORE Ltd guarantees its lighting systems and associated accessories against manufacturing defects for a period of three years from the original purchase date.

The warranty may be void in cases of misuse, abuse, incorrect installation, negligence, damage caused by disasters, installation by unqualified personnel, unauthorized repair or modification, or unapproved installations. Failure to comply with the installation, maintenance, and usage guidelines in the installation document also constitutes a breach of warranty conditions, as does the use with third-party drivers.

The Garmin LUX SL180 light strip is supplied as a pre-cut, factory-sealed unit with integrated 3M adhesive. Mechanical mounting clips, while recommended for certain installations, are optional accessories and not included by default.