LUX SL180, bandă de iluminat, CRGBW, 4600mm

The Garmin LUX SL180 light strip has a total length of 4600 mm (4.6 meters).

The LUX SL180 light strip is a full-spectrum CRGBW lighting solution. It provides adjustable colors across the entire spectrum, including cold and warm whites with a color temperature adjustable from 2700K to 6500K.

Yes, the LUX SL180 LED strip has an IP68 protection rating. This means it is designed to resist dust and temporary immersion. It can be installed in wet areas, but is not intended for permanent submersion in water.

The LUX SL180 LED strip integrates a seamless diffuser for uniform and homogeneous light diffusion.

Yes, it is constructed from UV-resistant material and passes salt spray tests, ensuring durability in marine environments.

The LUX SL180 light strip consumes an average of 8.7 W per meter. It consumes a maximum of 0.6 A/m at 12 V or 0.36 A/m at 24 V.

The light strip can be installed using its integrated 3M adhesive strip. For outdoor installations, wet areas, or tight bends, it is recommended to use mechanical fasteners (mounting clips) in addition to the adhesive, every 25 to 30 cm and/or on each side of a bend.

Ensure the vessel's power source is disconnected or isolated before installation. Bend the strip only along the vertical axis, with a minimum bend radius of 50 mm. Do not bend it along the horizontal axis or twist it. Do not apply pressure on the LED area; press only the edges of the strip. For lengths over one meter, it is recommended to use two people for installation. Unroll the strip carefully and lay it flat in a straight line without bending, twisting, or coiling it.

The LED strip should not be installed in areas exposed to direct sunlight, even if it is made from UV-resistant material. It is also not designed to be permanently submerged in water.

Yes, it is recommended to thoroughly clean the mounting surface using IPA (isopropyl alcohol) to ensure it is free of dust and dirt before applying the 3M adhesive tape. Allow the adhesive to cure for 24 hours before powering on the LED strip.

The LUX SL180 LED strip is designed for exclusive use with Lumishore LUX Strip Light Driver modules.

No, the LUX SL180 LED strip must not be connected to third-party lighting control products or drivers. It must be used exclusively with Lumishore LUX Strip Light Driver control modules. Using other drivers will void the warranty.

The LED strip operates on a voltage range of 10.5 to 31 VDC when connected via a LUX Lumishore control module.

Lumishore Ltd guarantees its lighting systems and associated lights and accessories against manufacturing defects for a period of three years from the original purchase date.

The warranty may be voided in case of misuse, abuse, incorrect installation, negligence, improper shipping, damage caused by disasters (e.g., fire, flood, storm, and lightning), installation by unqualified personnel, unauthorized repair or modification, or unauthorized installations. Additionally, non-compliance with all installation, maintenance, and usage instructions in the documentation also voids the warranty. Use with third-party drivers also voids the warranty.

The LED strip is supplied in pre-fabricated and factory-sealed lengths to ensure IP68 compliance. It is ready for installation but must be connected to a Lumishore LUX Strip Light Driver control module (sold separately).

For narrow mounting channels, stainless steel metal clips can be optionally supplied by Lumishore. These clips are secured using a countersunk screw. They should be gently opened, the light strip inserted, and then gently tightened around the strip.

The product is marketed under the Garmin brand, but it is a Lumishore lighting solution (Garmin Lumishore LUX SL180). Lumishore is a brand specializing in marine lighting, part of the Garmin ecosystem.