LUX SNL180, bandă LED neon Superbright Flex, 1400mm

The LUX SNL180 light strip has a length of 1400 mm.

The LUX SNL180 strip provides homogeneous LED lighting with no visible hotspots, thanks to an advanced diffusion layer. It features full-spectrum CRGBW lighting.

This LED strip provides CRGBW lighting, which includes cool white, red, green, blue and warm white.

Yes, the color temperature of the white light is adjustable from 2700K (warm white) to 6500K (cool white), allowing precise customization of the lighting ambiance.

The LUX SNL180 panel has IP67 certification. This means it is suitable for installation indoors or outdoors, including in damp areas, but is not designed for permanent immersion in water.

Yes, it is made from UV-resistant materials and has undergone salt spray testing, ensuring durability for marine applications.

The LUX SNL180 strip integrates 180 LEDs per meter, providing dense and bright illumination.

The LUX SNL180 strip has a nominal power output of 5 watts per meter. For a length of 1400 mm (1.4 meters), the total power consumption is approximately 7 watts.

No, the LUX SNL180 L-band cable is supplied in pre-cut lengths ready for use and is factory-sealed to meet IP67 standards. It must not be cut.

The minimum bending radius allowed for the LUX SNL180 cable is 120 mm. It must be bent only along the lateral axis and must not be bent vertically or twisted.

Always unroll the neon strip carefully along its entire length. Do not drop it or twist it during installation. Do not apply excessive pressure, as this could damage the internal LED strip. Do not pull, stretch, twist, or bend the strip on the vertical axis. For lengths over one meter, it is recommended to use two people for installation.

Its "bend-flex" design allows it to be adapted to curved surfaces, such as under coamings, T-tops, or cabin ceilings. It must be bent only along the lateral axis.

The strip is installed using the supplied stainless steel clips. These clips are screwed into place, then the neon strip is simply pushed into the clips until an audible "click" confirms it is securely fastened. It is recommended to use multiple clips around tight curves.

Yes, before any installation, always ensure the vessel's power source and battery are disconnected or isolated. It is also recommended that a qualified professional performs the electrical and mechanical installation.

Although the neon strip is made from UV-resistant materials, it should not be installed in areas exposed to direct strong sunlight.

Yes, the LUX SNL180 LED strip is designed to be used exclusively with Lumishore LUX Neon Flex driver modules.

No, it is imperative not to connect the LUX SNL180 L-band to lighting control products or third-party drivers. It must be used exclusively with Lumishore LUX light strip driver modules.

The required input voltage range is 23 to 25V. It must only be used with Lumishore LED strip driver modules.

The warranty may be voided in case of misuse, abuse, incorrect installation, negligence, damage caused by disasters, installation by unqualified personnel, unauthorized repair or modification, or unapproved installations. Failure to comply with installation, maintenance, and usage guidelines also voids the warranty.

Yes, using the LUX Neon Flex light strip with third-party drivers will void the warranty. It is designed to operate only with the Lumishore LUX light strip driver module.