ECLIPSE SNL100, bandă Neon Flex albastră, 5 m

The Lumishore ECLIPSE SNL100 is a flexible linear lighting solution designed for boats. It provides uniform, shadow-free illumination, ideal for decorative interior and exterior installations.

This specific model of the ECLIPSE SNL100 flexible neon emits a blue light.

The Lumishore ECLIPSE SNL100 is supplied in a 5-metre length.

The ECLIPSE SNL100 flexible LED strip consumes approximately 5 Watts per meter for each lighting channel.

Yes, the Lumishore ECLIPSE SNL100 is fully waterproof with IP68 certification. It can be installed in wet areas, both indoors and outdoors. However, it is not designed for continuous submersion in water.

Yes, the ECLIPSE SNL100 flexible neon is made from UV-resistant material. However, it is recommended not to install it in areas exposed to strong direct sunlight.

Yes, the flexible neon can be cut to the desired length. It is important to cut only at the marked cutting points and to use the provided sealing kit to reseal the cut ends before installation.

This flexible neon light is versatile and can be installed indoors as well as outdoors, including in wet areas. It is ideal for under-gunnel strips, cabin ceilings, and T-tops, thanks to its flexibility.

Before any installation, it is imperative to ensure that the vessel's power source and battery are disconnected or isolated. Electrical and mechanical installation must be performed by a qualified professional.

To avoid damaging the flexible neon strip:

Always unroll it carefully along its full length; do not handle it by a single end. Do not drop it or allow it to twist. Do not apply excessive pressure. Do not pull, stretch, twist, or bend it along the vertical axis. For lengths over 1 meter, it is recommended to use two people for installation.

The minimum bending radius for the ECLIPSE SNL100 flexible neon is 120 mm (4.724 in) on the vertical axis. It must not be bent on the horizontal axis or twisted.

After cutting the flexible neon at the marked points with scissors, use the provided sealing kit. It is recommended to wrap the flexible neon during this process to retract the printed circuit board (PCB), which will prevent the sealant from covering the LEDs and avoid discoloration.

The flexible neon is designed to operate only with 12V DC boat electrical systems. It can function within a voltage range of 10V to 15V DC.

No, the ECLIPSE SNL100 flexible neon must never be connected to an AC voltage or to any voltage outside the 10–15 V DC range.

The blue flexible neon lighting can be controlled in two ways:

Via a simple on/off switch. Via an ECLIPSE control hub for more advanced management.

No, it is important not to add monochrome lights (such as this blue neon), bicolor, and RGB to the same zone output of an ECLIPSE control panel. Each type of light must use a separate zone output.

The Lumishore ECLIPSE SNL100 comes with a 3-year warranty.

The ECLIPSE SNL100 flexible LED strip integrates 60 blue LEDs per meter, ensuring uniform and continuous illumination.