Panoptix™ PS70, doar sondă

The Garmin Panoptix™ PS70-TH transducer is a through-hull solution designed for integrating advanced Garmin sonar systems. It is optimized for superior hydrodynamic performance and increased durability, essential for offshore navigation and demanding sport fishing applications. It delivers detailed sonar images beneath the boat.

This through-hull transducer is compatible with fiberglass hulls (whether single-piece or sandwich construction) as well as metal hulls.

For optimal performance and to avoid potential injury or damage to the device or your vessel, installation by a qualified marine technician is recommended.

Yes, several locations should be avoided:

Avoid turbulence: The transducer must not be mounted behind frames, struts, fittings, water intake or discharge openings, or anything that creates air bubbles or causes turbulent water. It must be in calm (non-turbulent) water for optimal performance.
Avoid shocks: The transducer must not be mounted where it could be shaken during launching, towing, or storage.
Avoid the propeller: On single-screw boats, the transducer must not be mounted in the propeller wash, as it can cause cavitation.
Avoid heat: To prevent overheating and interference, do not install the transducer near the engine, in the engine room, or in any other hot location.

Yes, you must update the software of your Garmin chartplotter when you install this device. Instructions for updating the software are in your chartplotter’s owner’s manual.

To prevent leaks, you must apply marine sealant along the water path between components to ensure a watertight seal between the transducer and the hull. The sealant must be applied between the following elements:

The fairing block and the hullThe fairing block and the transducerThe fairing block and the anti-rotation bolt capThe bolt holes and the transducer cable rodThe rod and the hull nutThe rings, the rod, and the hullThe transducer and the hull pocketIt is critical to immediately check for leaks after launching the vessel.

No, the fairing block is used when the transducer is mounted in a hull location with a deadrise angle of 20 degrees or less. However, if the transducer is installed in a dedicated hull pocket, the anti-rotation bolt and fairing block are not used.