Automatický nabíjecí relé ML-ACR s ručním ovládáním - 24 V DC 500 A

This BLUE SEA ML-ACR automatic charge relay (model 7623-BSS) is designed to work with 24V DC electrical systems.

The ML-ACR 7623-BSS automatic charge relay has a continuous current capacity of 500 amperes (A). It can also handle intermittent currents of 700A for 5 minutes and starting currents of 1450A for 30 seconds.

The Magnetic Latch (ML) technology allows the relay to maintain its state (ON or OFF) with extremely low current consumption. This optimizes battery life. Continuous consumption is less than 13mA and less than 7.0A during state changes.

The relay automatically combines battery banks when the charging voltage exceeds:

27.0V for 30 seconds or 26.0V for 90 seconds. This ensures batteries are charged together when a charging source is detected.

The relay automatically isolates battery banks if the voltage drops below:

24.7V for 10 seconds or 25.5V for 30 seconds. It also isolates batteries in case of undervoltage (below 19.2V) or overvoltage (above 32.4V).

Yes, this ML-ACR model is equipped with manual control via a remote Contura switch (PN 2146), which is included. This provides additional safety and allows manual intervention even without power.

The Start Isolation (SI) function allows temporary isolation of the house battery loads from the engine circuit during startup. This protects sensitive electronic equipment from voltage drops and spikes that can occur when the engine starts.

No, the ML-Series ACR can be configured for Start Isolation (SI) or Engine Isolation (EI) function, but not both simultaneously.

The relay includes lockout functions to protect the system:

Undervoltage lockout: Batteries are not combined if any one is below 19.2V DC. Overvoltage lockout: Batteries are not combined if any one is above 32.4V DC.

This relay uses 3/8"-16 tinned copper terminal studs. They provide maximum conductivity and excellent corrosion resistance, essential in a marine environment.

The BLUE SEA ML-ACR is designed to be robust in marine environments. It is rated IP66, meaning it is protected against powerful water jets. It also meets external ignition protection requirements per ISO 8846 and SAE J1171, and is CE marked.

The maximum recommended torque for terminal studs is 140 in-lb (15.8 N•m). It is important to respect this value to ensure a secure connection without damaging the relay.

For a continuous capacity of 500A, it is recommended to use 2 cables of 4/0 AWG (2x 120 mm²). This ensures adequate and secure power distribution.

The included remote control switch has an LED indicator that provides a clear system status:

LEDs off: Batteries are isolated.
LEDs on: Batteries are combined.
LEDs flashing slowly: Start isolation or engine activated.
LEDs flashing rapidly: Lockout due to undervoltage or overvoltage.
LEDs double flash: Manual control activated or relay mechanical failure.

The ML-ACR standard (model 7623-BSS) is optimized for AGM/GEL to AGM/GEL and AGM/GEL to Lithium configurations. However, it is not suitable for Lithium to Lithium or Lithium to lead-acid configurations due to its predefined voltage thresholds. Blue Sea Systems offers a specific ML ACR Li-Ion version for these applications.

Yes, this ML-ACR automatic charge relay is designed to handle high-efficiency alternators and large battery banks, with a continuous capacity of 500A.

Blue Sea Systems supports its products for as long as you own them. This warranty reflects the manufacturer’s confidence in the durability and reliability of its equipment.

The relay ground wire must be connected to a common ground or directly to the battery negative terminal. Correct connection is essential for proper system operation and safety.