Přepínač baterie série m 300 A červený dvoupólový

This Blue Sea Systems Series m bipolar battery switch is designed to switch two isolated battery banks simultaneously or to manage positive and negative conductors, depending on the required configuration. It enables simplified and secure electrical management on board boats and recreational vehicles.

The Blue Sea Series m 6010B-BSS battery switch has a continuous rated current of 300 amperes (A) DC per circuit.

This switch is designed to operate with a maximum voltage of 32 volts DC.

Yes, this switch is protected against external ignition. It complies with UL 1500 and SAE J1171 requirements, ensuring safe installation on gasoline-powered boats. It is also CE certified according to ISO 8846.

The switch has an IP66 protection rating, meaning it is resistant to dust and powerful water jets.

To comply with the switch specifications, it is recommended to connect a 4/0 AWG (120 mm²) cable per terminal.

Battery cable terminals must be secured under the lock washer and nut with a torque of 13.56 N·m (120 lb-in).

The terminal studs are tinned copper and measure 3/8"-16 (M10), allowing them to accept eye terminals of this size.

No, it is critical not to set the switch to OFF when the engine is running, to avoid damaging the alternator.

Yes, the m 300A battery switch is specifically rated for outboard motors and small gasoline or diesel engines.

This switch offers several mounting options: surface mounting, front panel mounting, and rear panel mounting.

This switch complies with ABYC (American Boat and Yacht Council) requirements, is UL 1107 listed for electrical power switches, and meets UL 1500 and SAE J1171 standards for external ignition protection. It is also CE certified to ISO 8846.

The switch can handle an intermittent current of 450 amperes (A) DC per circuit for 5 minutes.

This switch has a rated starting current of 675 amperes (A) DC per circuit for 30 seconds.

Yes, the "Dual Circuit" (bipolar) design of this switch allows simultaneous switching of two battery banks while keeping them isolated from each other.

The terminal studs are 7/8" (22 mm) long, allowing them to accept multiple cable terminals.

This battery switch from the m 300A series is red.

Yes, Blue Sea Systems products are generally covered by the manufacturer's warranty.

Yes, it is recommended to consult a marine electrician to ensure the wiring is properly installed and compliant with applicable uses and current standards.