ECLIPSE SL100, bílá LED páska, 2,5 m

This Garmin ECLIPSE SL100 light strip emits white light with a color temperature of 5000 K.

The ECLIPSE SL100 light strip has a length of 2.5 meters.

Yes, the LED strip is fully encapsulated and sealed, providing IP68 protection. It can be installed indoors or outdoors, including in wet areas. However, it is not designed for permanent immersion in water.

The ECLIPSE SL100 LED light bar is designed to operate exclusively on 12V DC boat systems. It can function within a voltage range of 10 to 15V DC. Do not connect it to voltages outside this range or directly to AC power.

The maximum electrical consumption of the LED strip is 6 watts per meter. Typical current draw is 0.5 A at 12V.

Yes, the tape has a minimum bending radius of 50 mm (1.968 inches) only in the vertical axis. It is important not to bend it in the horizontal axis or twist it.

To cut the light strip:

Unroll the strip on a flat surface and identify the end to be cut. Measure and mark the required length, ensuring you only cut at the marked cut points. Use a pair of scissors to cut the strip in one single motion at the center of the cut tabs.

Yes, it is essential to seal the cut end to maintain waterproof properties. The process involves peeling 20mm of the adhesive backing, lightly scoring the adhesive 10mm from the end, removing the tape to expose the silicone, half-filling the end cap with the supplied silicone adhesive, then securing the cap. Allow to cure for 24 hours before handling.

The LED strip comes with a 3M adhesive backing. Clean the mounting surface thoroughly with isopropyl alcohol (IPA) to ensure it is free of dust and dirt. Then, remove the adhesive film and press the strip firmly, applying pressure only to the edges (not the LEDs). Allow the adhesive to cure for 24 hours before powering on the strip.

For outdoor installations in wet areas or with tight bend radii, it is recommended to use mechanical fasteners (mounting clips) in addition to the adhesive layer. These fasteners should be placed every 250 to 300 mm and/or on each side of a bend, avoiding alignment with the LEDs.

It is recommended that a qualified professional perform the electrical and mechanical installation to ensure correct and safe installation.

Yes, the LED strip is made from UV-resistant material. However, it must not be installed in areas exposed to direct and intense sunlight to preserve its long-term durability.

The light strip has a width of 10.8 mm and a height of 5.2 mm.

For a simple connection, the single-channel LED strip can be connected to a power switch. The red wire of the strip is connected to +12V (via a fuse), and the black wire is connected to the switch, which in turn is connected to ground (GND).

Yes, the ECLIPSE SL100 white LED strip is compatible with an ECLIPSE control unit. For installation with the control unit, the red wire of the ECLIPSE cable harness must be connected to the red wire of the strip, and the blue and white wires of the ECLIPSE harness must be connected to the black wire of the strip.

No, it is important not to add single-color, dual-color, and RGB lights to the same zone output. Use a separate zone output for each type of light strip.

Yes, during installation, unroll the strip carefully from the reel and do not let it drop or twist. Do not apply pressure on the LED area; press only on the edges of the strip. Do not pull, stretch, twist, or bend the strip along the horizontal axis. For lengths over one meter, it is recommended to use two people.

If the adhesive is not properly removed from the sealing end or if the sealing process is not performed correctly, this could compromise the waterproof properties of the assembly and risk voiding the warranty.

The ECLIPSE SL100 light strip has a density of 60 LEDs per meter, providing uniform lighting.

No, the ECLIPSE SL100 LED strip is designed to operate only with 12V DC systems. Do not connect it directly to an AC voltage.