EOS SMX154, povrchový světlomet

The Garmin Lumishore SMX154 underwater light delivers a total luminous flux of 15,750 lumens. In white light, it produces 7,000 verified lumens, ensuring significant underwater illumination.

The SMX154 features an RGBW LED configuration (red, green, blue, white). It is equipped with 12 white 10W LEDs, 12 green 3W LEDs, 12 blue 3W LEDs and 16 red 3W LEDs.

The Garmin SMX154 spotlight is a surface-mount model.

The LED lifespan of the Garmin SMX154 spotlight is estimated at over 50,000 hours, minimizing maintenance requirements.

The SMX154 spotlight operates on a voltage of 10.5–31 VDC, making it compatible with 12V and 24V DC systems.

Each SMX154 floodlight consumes 4A at 12V and 2A at 24V, with an average power consumption of 48W.

The SMX154 spotlight is designed for advanced integration with Garmin navigation systems.

For mechanical installation, you will need the following tools:

A drill and drill bitsMarine sealant (e.g. 3M 4200 or equivalent)A type F2 Frearson screwdriverA flathead screwdriverRags for cleaning

You will need to drill pilot holes of 9/64” (3.5mm) for the screws and a 17/32” (13.5mm) hole for the cable and gland. The cable hole must be chamfered on the outside to accept the gland.

For optimal underwater lighting, install the underwater light between 100 and 300 mm (4 to 12 inches) below the minimum waterline.

No, the underwater light must be mounted on a flat surface of the hull. For underwater installations, it must be mounted only on the transom or the side of the hull.

A thick and continuous bead of sealant must be applied to the rear of the light fixture, ensuring that the recess on the outer edge slightly overflows. Also apply a bead of sealant around the cable gland. Cored hulls must be sealed before installation, following the manufacturer's instructions.

No, it is important not to overtighten the screws and not to use power tools to secure them. Tightening must be done by hand with a screwdriver.

This spotlight is designed for boats up to 15 meters (50 feet).

The SMX154 spotlight has a 90° beam angle, ensuring extended coverage around the hull.

You will need an EOS i-Connect hub. A single hub can power up to 4 projectors.

Yes, it is possible to connect up to 4 EOS i-Connect hubs together in the same system. To add additional hubs, you will need one or more EOS i-Connect hubs (reference 60-0321) and DMX extension cables.

The hub must be installed in a dry, well-ventilated location, not prone to flooding or excessive heat. It should be mounted on a flat surface with sufficient access to the fuse panel and connectors, and as close as possible to the power source.

Yes, power cables can be extended using the correct cable gauge to avoid voltage drops. It is recommended to follow ABYC guidelines for a maximum voltage drop of 3% for 12V and 10% for 24V systems. Lighting cables can be extended by 3 meters, but only with Lumishore extension cables (part number 60-0407).

The SMX154 floodlight is constructed with a marine-grade bronze body and a borosilicate glass lens, providing high durability and resistance to marine environments.