Lux NeonFlexStripLt SNL180CRGBW-1600mm, LS, (60-0382-1600)

The Garmin Lux NeonFlexStripLt SNL180CRGBW light strip measures 1600 mm, which is 1.6 meters in length.

This LED strip provides full CRGBW color lighting, including cold white, red, green, blue, and warm white. Additionally, it allows white temperature adjustment from 2700K to 6500K.

The SNL180CRGBW-1600mm model integrates 180 LEDs per meter, ensuring high light density.

No, it is essential not to cut the Neon Flex light strip. It is supplied in ready-to-use lengths and factory-sealed to meet IP67 standards.

The diffusion layer of the strip is designed to create uniform light without visible hotspots, providing superior aesthetic rendering compared to traditional LED strips.

The LUX SNL180 light strip is fully sealed and has an IP67 protection rating. It can be installed in damp areas but is not designed for permanent submersion in water.

Yes, it can be installed indoors or outdoors. However, although it is made from UV-resistant material, it must not be installed in areas exposed to direct strong sunlight.

The LUX Neon Flex Strip Light LED strip is designed for use exclusively with Lumishore LUX Neon Flex Strip Light Driver control modules. It must not be connected to any other third-party lighting control products or drivers.

The Lumishore LUX Strip Light Driver control module requires an input voltage range of 23 to 25 VDC.

The maximum current draw of the strip is 0.6 A at 12 V and 0.36 A at 24 V, via the dedicated Lumishore strip controller. The nominal power is 5 watts per meter.

The Neon Flex strip is installed using the provided stainless steel clips. These clips are screwed into place, then the strip is simply pushed in until a 'click' confirms it is securely fixed. It is recommended to use multiple clips around tight curves.

It is essential to always ensure that the vessel's power source and battery are disconnected or isolated before proceeding with installation.

The minimum bending radius is 120 mm. It is critical to bend the strip only on its side and never bend it on the vertical axis or twist it.

No, the strip must be folded only on the side. Do not fold it on the vertical axis or twist it. Applying excessive pressure, pulling, or stretching the strip can damage the internal LED strip.

Yes, it is strongly recommended that a qualified professional performs both the electrical and mechanical installation of the LED strip.

Using third-party autopilot brands with the LUX Neon Flex Strip Light will void the product warranty. It is designed to operate exclusively with the Lumishore LUX Strip Light Driver control module.

Never unroll the tape by holding it by only one end; always carefully unroll it along its entire length. Do not let it drop or twist during installation. For lengths over one meter, always use two people: one for installation and one to hold and unroll the tape.

Yes, it fits into Garmin/Lumishore’s advanced marine lighting range, complementing existing systems with centralized control options via the LUX control module.

The 'bend-flex' design allows the light strip to conform to curved surfaces, making it ideal for installations under coamings, cabin liners, or T-tops.

The warranty may be void in case of misuse, abuse, incorrect installation, negligence, installation by unqualified personnel, unauthorized repair or modification, or use of non-approved installations. Failure to comply with installation guidelines and user instructions, including use with third-party autopilots, also constitutes non-compliance with warranty terms.