LUX SL180, pásové světlo, CRGBW, 4300 mm

The Garmin LUX SL180 is a 4300 mm CRGBW light strip designed for ambient and functional lighting aboard vessels. It provides full-spectrum color capability and tunable white.

The LUX SL180 LED strip is of type CRGBW, meaning it integrates Red, Green, Blue, Cool White and Warm White LEDs. The white is tunable, covering a temperature range from 2700K to 6500K for enhanced versatility.

The total length of the Garmin LUX SL180 LED strip is 4300 mm.

Yes, this LED light bar is IP68 certified, ensuring complete protection against dust and temporary immersion. It is made from UV-resistant material and has been tested against salt spray, making it suitable for indoor and outdoor marine environments, except for permanent submersion.

The power consumption of the LED strip is 5 watts per meter. The maximum current draw is 0.6 A/m at 12 V and 0.36 A/m at 24 V, for an average power of 8.7 W/m.

The LED strip has a width of approximately 14.5 mm and a height of approximately 14.15 mm, allowing discreet integration into various spaces on the boat.

Each meter of the Garmin LUX SL180 LED strip integrates 180 CRGBW LEDs.

No, the LUX SL180 LED light strip is supplied in pre-cut, factory-sealed lengths to meet IP68 standards. It must never be cut.

The LED strip is equipped with a 3M adhesive backing. For outdoor installation in wet areas or for tight radii, it is recommended to use additional mechanical fastenings, such as mounting clips, spaced 25 to 30 cm apart or on either side of a bend. Stainless steel metal clips can also be provided as an option by Lumishore for narrow mounting channels.

The light strip has a minimum bending radius of 50 mm on the vertical axis only. It must not be bent on the horizontal axis or twisted.

Yes, it is imperative to always ensure that the vessel's power source and the battery are disconnected or isolated before starting any electrical or mechanical installation. It is also recommended that a qualified professional carry out the installation.

Although the LED strip is made from UV-resistant material, it must not be installed in areas with strong direct sunlight exposure.

The mounting surface must be thoroughly cleaned using isopropyl alcohol (IPA) and ensured to be free of dust and dirt. After removing the protective film from the 3M adhesive, firmly press the strip into place by applying pressure only along the edges, without pressing on the LEDs. Allow the adhesive to cure for 24 hours before powering on the strip.

It is recommended to always use two people to install strip lengths longer than 1 meter: one person for installation and another to hold and carefully unroll the strip.

No, the LED strip should only be bent along the vertical axis, with a minimum radius of 50 mm. It is essential not to bend it along the horizontal axis or twist it.

For outdoor installations, wet areas, or tight bends, it is strongly recommended to use mechanical fastenings, such as clips, in addition to the adhesive layer. These clips should be spaced 25 to 30 cm apart or placed on each side of a bend.

The LUX SL180 LED strip is designed for use exclusively in conjunction with Lumishore LUX Strip Light driver modules.

No, the LUX SL180 LED strip must be connected only to Lumishore LUX Strip Light driver modules. Using third-party control products or drivers not approved by the manufacturer will void the product warranty.

LUMISHORE Ltd guarantees its lighting systems and accessories against manufacturing defects for a period of three years from the original purchase date.

The warranty may be voided in case of misuse, incorrect installation, negligence, damage caused by disasters (e.g., fire, flood, storm, and lightning), installation by unqualified personnel, unauthorized repair or modification, or non-compliance with the installation, maintenance, and use guidelines in the document. Using third-party drivers not approved by Lumishore will also void the warranty.