SUPRA THX1604, podvodní světlomet s driverem

The Garmin SUPRA THX1604 underwater lighting system delivers a total luminous output of 45,000 lumens. For white light, it provides up to 20,000 lumens per fixture.

The SUPRA THX1604 model (SKU 010-04519-00) is a two-tone version featuring blue and white lighting.

The HICOB Array LEDs integrated into the SUPRA THX1604 provide a typical lifespan of over 50,000 hours.

The maximum consumption of the SUPRA THX1604 system is 6.5 A at 24 VDC, with an average power of 156 W.

The SUPRA THX1604 is designed to provide an ultra-wide 110-degree beam, ensuring extended underwater illumination.

The LUMISHORE Thru-Hull is suitable for many types and sizes of boats, including sports boats, motorboats, yachts, and superyachts.

The light must be installed between 150 and 250 mm (6 to 10 inches) below the minimum loaded waterline.

The light must be installed on a flat (non-curved) surface of the hull. It can only be mounted on the transom or the side of the hull.

Yes, for installations on wooden, metal or carbon fiber hulls, an insulation kit will be required. It is not required for GRP hulls (glass-reinforced plastic or fiberglass).

To achieve the best results, it is recommended to install the lights at a distance of 0.8 meters to 2 meters (2.5 feet to 6.5 feet) apart.

Before any installation, ensure that the vessel's power source and battery are disconnected or isolated. Additionally, a qualified professional should carry out the electrical and mechanical installation.

No, the 3-meter (10-foot) pre-installed cable connecting the lighting to the external autopilot module must not be cut or extended.

Yes, the 1-meter (3-foot) power cable of the external autopilot module can be extended using pre-terminated Lumishore extension cables (part number PN: 60-0401).

The SUPRA THX1604 system operates on 24 VDC, with an acceptable operating range of 20 to 31 VDC.

The SUPRA i-Connect Hub and external pilot modules must be installed in a dry and well-ventilated location.

Yes, all LUMISHORE products must be grounded to the DC system via a bonding strap for galvanic protection. This grounding is not required for fully submerged lights at the bow and stern.

The torque on each mounting bolt must not exceed 3 Nm (26 in-lbs). It is important not to overtighten the bolts.

Yes, optional control via MFD is possible using the Lumi-Link SUPRA bridge module (PN: 60-0368) and a Garmin marine network cable.

A system can support a maximum of 16 i-Connect hubs, allowing a total of 64 lights to be connected.

Incorrect electrical installation or failure to respect correct electrical polarity will void the system warranty.