Zakřivená LED lišta 30 palců

This curved LED bar has a length of 30 inches, which corresponds to approximately 749 mm (dimension E in the installation diagram).

It is designed for demanding marine applications and is optimized for installation on T-tops, helm roof tops, fishing towers, and bow platforms.

This LED bar delivers a total of 53,460 lumens. The actual luminous output (fixture lumens) is 23,760 lumens.

Yes, the light is dimmable (adjustable intensity). It emits a white light with a color temperature of 5000 K, providing optimal clarity.

Yes, the beam angle is adjustable and can be set from 9 to 32 degrees, allowing precise focusing of the light according to your needs.

The housing is made of powder-coated aluminum and the lens is made of Makrolon. These materials give the product IP68-rated waterproofing, ensuring protection against water and dust in harsh marine environments.

LED lifespan is estimated at over 50,000 hours, ensuring a long period of reliable use.

The 30-inch LED light bar is equipped with 60 white LEDs, each rated at 10W.

This LED bar operates within a voltage range of 10.5 to 31 VDC.

The maximum power consumption for the 30-inch model is 19.3 A at 12 V and 9.7 A at 24 V.

You can control it in several ways:

Via a simple on/off switch.Via a multifunction display (MFD) using an LUX lighting control module.Via an ECLIPSE control center.

Yes, this LED bar is optimized for seamless integration within an existing Garmin ecosystem, providing a powerful and coordinated lighting solution.

No, the ECLIPSE control unit is only suitable for boats operating on 12V. For other voltages, alternative control methods are available.

Yes, each lighting circuit must be fused appropriately to ensure safety and system protection.

This product must be installed, inspected, and maintained only by a qualified electrician, in accordance with all applicable electrical codes.

The package includes the curved LED bar, M6 hex bolts of various lengths, M6 flat washers, M6 nylon washers, M6 spring washers, M6 nylon insert nuts, two brackets, two flat plates, and two drilling templates for the brackets.

To avoid glare, it is recommended to find a position and adjust the light's tilt so that no light falls on the bow of the boat. You can use a string stretched from the bow to the top of the light to visualize the area.

You will need to drill a 4 mm pilot hole, followed by a final diameter of 6.5 mm for the M6 mounting bolts.

Yes, it is strongly recommended to use marine sealant (such as 3M 4200) inside and around mounting holes, as well as to seal the cable entry. Using a cable gland for the cable is also advised.

Yes, if a light angle adjustment is needed after installation, it is important to loosen ALL bolts (those on the mounts and those securing the mounts to the boat) before making the adjustment, then retighten them to the recommended torque (8Nm for the side bolts of the mounts).