Montážní sada pro sondu CPT-S na zádní desku

The CPT-S Raymarine R70496 sonar mounting kit is designed for installing CHIRP CPT-S transducers on the transom of your vessel. This kit provides a stable mount and allows precise adjustment of the transducer position, which is essential for optimizing CHIRP cone sonar signal quality.

This kit is specifically designed for Raymarine CPT-S transducers. These transducers are typically installed on chartplotters such as Raymarine Dragonfly units or multifunction displays (MFD) compatible with LightHouse II software (version 16) from 2016.

To ensure watertightness during installation, you must use a high-quality marine-grade neutral-cure polyurethane sealant. It is critical not to use sealants containing acetate or silicone, as they could potentially damage the plastics of the transducer and its mounting bracket.

Yes, a mounting template is provided with the kit. It simplifies drilling the mounting holes for the bracket and the adjustment slots, allowing precise positioning for clear and reliable sonar readings.

After initial installation, it is recommended to perform a test in the water. This step allows you to finalize the angle and depth of the transducer by adjusting its position in the adjustment slots. The locking hole should only be drilled and the final screw tightened once the optimal position is found and validated, ensuring optimal performance and eliminating turbulence.

Yes, cutting the depth sounder transducer cable significantly reduces the fishfinder’s performance and voids the product warranty. Additionally, it invalidates the European CE mark. If the cable is damaged, it must be replaced and cannot be repaired.

No, it is essential to test and use the transducer only when it is submerged in water. Using the transducer out of the water can cause overheating and damage the device.

The CPT-S transducers use CHIRP cone-beam technology. This technology provides target separation and seabed resolution suited to navigation and coastal fishing.