Napájecí kabel radaru QUANTUM 10 m

This cable is designed exclusively to supply power to your Raymarine Quantum radar antenna from your boat's distribution panel.

This specific model (reference A80309) measures 10 meters in length, which is generally ideal for installation on a davit or the mast of a mid-sized boat.

No, this is a cable strictly dedicated to power supply. It is suitable if you use your Quantum radar in Wi-Fi mode for data transmission to your chartplotter.

Yes, the cable is fitted with an overmolded connector that ensures perfect watertightness against spray and rain once properly connected to the radome.

Absolutely. The cable sheath is designed to withstand UV rays and extreme marine environments, which is essential for an outdoor installation at the masthead.

Using the original cable ensures the radar's performance is maintained and prevents voltage drops along the line, which could cause unintended restarts or a loss of range.

The manufacturer reference for this 10-meter power cable from Raymarine is A80309.

Yes, this power cable is fully compatible with all first-generation Raymarine Quantum radars.

Yes, it is fully compatible with the Quantum 2 radar range featuring Doppler effect.

No, this cable is specifically designed for the Quantum pulse-compression radar range and will not fit older analog models.

No, the overmolded connector is proprietary and designed solely to fit Raymarine equipment.

Yes, this is the ideal choice. The radar transmits image data wirelessly via Wi-Fi, so you only need this cable to supply the electrical power it requires.

Simply insert the overmolded connector into the dedicated power port located under the Quantum radome, then tighten the locking ring to ensure secure attachment and waterproofing.

If 10 meters are not enough, it is strongly discouraged to splice the cable to extend it, as this can cause voltage drops. Raymarine offers versions of this cable in longer lengths suitable for large vessels.

Yes, you can trim the excess cable on the electrical panel side (stripped wire side) to neatly fit your installation. However, make sure to keep a small safety margin.

The end opposite the radar has bare wires that must be connected directly to your electrical distribution panel (12V or 24V), respecting the polarities.

Yes, it is essential to protect the electrical line. You must install a fuse or a thermal circuit breaker properly sized according to the installation manual recommendations for your Quantum radar.

It is recommended to run the cable through a dedicated conduit inside the mast to prevent chafing (rubbing) against moving sheets, and to secure it with cable ties at the exit points.

As this is only a DC power cable (with no high-frequency data transmission), the risk of interference is very low. It is still advisable to follow standard separation rules with VHF antenna cables.

No, the radar side connection is made manually using the integrated threaded ring. You will only need standard tools (wire strippers, screwdriver) for the final connection to the boat's electrical panel.