Zakřivená LED lišta 40 palců

The Garmin 40-inch curved LED bar is equipped with 80 white 10 W LEDs, delivering a total luminous output of 31,680 lumens.

The specific dimensions for the 40-inch model are as follows:

A: 92 mm B: 132 mm C: 44° D (total length): 1070 mm E (mounting length): 999 mm

This LED bar produces a "letterbox" type beam, optimized for wide coverage. The vertical beam angle is 9° and the horizontal beam angle is 45°.

The Garmin LED bar emits a white light with a color temperature of 5000 K.

The Garmin curved bar has an IP68 rating. This means it is fully protected against dust and can withstand prolonged immersion in water, making it suitable for demanding marine environments.

The Garmin 40-inch curved LED bar integrates 80 white LEDs.

The LED bar operates on a direct current (DC) voltage between 10.5 V and 31 V.

The LED bar can be activated via a simple on/off switch or a momentary switch. For more advanced integration, it is compatible with a multifunction display (MFD) via a LUX light control module and an EOS-LUX control center. The ECLIPSE control center is suitable only for 12V boats.

The maximum electrical consumption of the light bar is 25.7 A at 12 V and 12.9 A at 24 V. A suitable electrical circuit is required for proper operation.

The package includes:

Curved LED bar (1)M6 x 40mm hex bolts (6)M6 flat washers (16)M6 x 16mm hex bolts (4)M6 nylon washers (4)Mounts (2)Flat plates (2)M6 spring washers (6)M6 nylon insert nuts (6)Drilling templates for mounts (2)

The installation involves temporarily assembling the mounts, finding a position that avoids glare from the bow, marking the tilt, then using the drilling template to make pilot holes of 4mm and final holes of 6.5mm. The mounts are then secured to the boat with marine sealant, and the light bar is mounted on the supports.

Yes, it is strongly recommended to use marine sealant (such as 3M 4200) around mounting holes and to seal cable entries to ensure optimal waterproofing.

A 9.5 mm diameter hole must be drilled for the cable pass-through. Using a cable gland is recommended to ensure perfect watertightness at this point.

To avoid glare on the bow, it is advisable to find a position and adjust the tilt of the light bar so that no light falls on the bow. One method is to use a string from the bow to the top of the light to visualize the beam and its impact.

Once the light bar is tilted to the desired angle, the bolts on the sides of each bracket must be tightened to a final torque of 8 Nm.

If an adjustment of the tilt is necessary after installation, it is important to loosen all bolts before proceeding with the adjustment. Once the angle is corrected, tighten the side bolts to 8 Nm.

Yes, the supplied distribution plate must be placed under the mounting surface. It ensures uniform distribution of force when tightening the bolts, which is crucial for the stability and durability of the installation.

This product must be installed, inspected and maintained only by a qualified electrician, strictly in compliance with all applicable electrical codes.

Wiring must be done according to ABYC guidelines. Each lighting circuit must be properly fused. The LED bar requires a 10.5 to 31 VDC power supply and draws up to 25.7 A at 12V or 12.9 A at 24V.

The Garmin 40-inch curved LED bar has a 3-year warranty.