Tradiční kovový DC rozvodný panel – 8 pozic

The Blue Sea 8023-BSS DC electrical panel is made from 3.175 mm (1/8 inch) thick 5052-H32 aluminum alloy. It has a textured graphite-colored polyurethane finish applied after chemical treatment compliant with military specification C-5541C, providing excellent corrosion resistance.

This panel is designed to continuously manage a total capacity of 100 amperes in direct current (DC).

The 8023-BSS panel integrates 8 circuit positions for electrical distribution.

The panel is supplied with five 15 A AC/DC magnetic circuit breakers (toggle type) from the A series already installed. Space is available for three additional circuit breakers if required.

Yes, the busbars in this panel are made of tinned copper, which optimizes their electrical conductivity and improves their resistance to corrosion, ensuring better durability in a marine environment.

Yes, each circuit label position is backlit for better visibility. In addition, 'ON' status LEDs are installed on all circuit positions for quick visual diagnosis of circuit states.

The overall dimensions of the 8023-BSS panel are 133.4 mm in height by 190.5 mm in width (5-1/4 inches x 7-1/2 inches).

Yes, the panel is supplied with a set of large-format DC labels (reference 8030) to clearly identify each circuit.

A marine electrical panel has several main purposes:

Power distribution.The protection of circuits (and wires) against overloads.Turning circuits ON/OFF.Indicating the status of circuits (whether they are live).

Yes, the panel is designed for DC electrical distribution and is compatible with 12 V or 24 V DC systems. Voltage identification labels are provided to clearly configure the panel according to your system's voltage.

Yes, the included 15-amp magnetic circuit breakers are AC/DC type, meaning they can be used to protect circuits powered by alternating current or direct current.

This panel complies with the standards and recommended practices of the American Boat and Yacht Council (ABYC) for small craft (sections E-1, E-3, E-9), as well as Subpart 1 of the U.S. Coast Guard electrical systems (33 CFR).

The panel is supplied with 15-amp circuit breakers. You may remove and replace these breakers with higher-rated ones if the branch circuits you wish to protect require it, always ensuring that the wire gauge is appropriate for the selected amperage.

Installing this product requires in-depth knowledge of marine electrical systems. If you are not familiar with these systems, it is strongly recommended to hire a professional electrician for installation to ensure safety and proper operation.

Before starting the installation, it is imperative to disconnect the main positive cable from all batteries to eliminate any risk of short-circuit. If your boat is connected to shore power, also unplug the AC power cord to avoid any risk of electrocution.

The panel must not be installed in explosive environments, such as gasoline engine rooms or battery compartments, as the circuit breakers are not spark-proof. It is also recommended to choose a location protected from water, both at the front and rear of the panel.

Specific labels are provided with the panel to permanently identify your system's voltage (12 V or 24 V DC) and type, as required by ABYC. You must apply the appropriate voltage label to the recessed area at the front of the panel.

For branch circuits, connect the positive wires (red) to the load terminals of each circuit breaker. Then connect each negative wire (black or yellow) to the DC negative bus of the panel. It is important not to confuse the DC negative bus with the DC ground bus.

To simplify installation and reduce assembly time, all positive, negative, and ground buses are pre-wired in the panel. This also helps minimize potential errors during connection.

Blue Sea Systems is committed to customer satisfaction. If a customer is not satisfied with this product, they may return it for a replacement at any time, in accordance with the brand's policy.